Adjusting the speaker output levels

	Section
Available accessories	19

#You cannot select Off, when Front (front speakers) have been selected.

#You can select On or Off, when Subwoofer (subwoofer) has been selected.

#You can switch Reverse (reverse phase) or

Normal (normal phase), when Phase (subwoofer setting) has been selected.

Correcting the subwoofer’s phase

If trying to boost the bass output of the sub- woofer doesn’t do much or rather makes you feel that the bass gets more murky, this may indicate that the subwoofer’s output and bass content you hear over other speakers cancel each other out. To remove this problem, try changing the phase setting for the subwoofer.

1Touch Speaker Setting.

2Touch a or b to select Subwoofer (sub- woofer).

Each time you touch aor b selects the speak- er in the following order:

Front (front speakers)—Center (center speak- er)—Rear (rear speakers)—Subwoofer (sub- woofer)—Phase (subwoofer setting)

3Touch d to turn subwoofer output on.

# To turn subwoofer output off, touch c.

4Touch b and then touch c or d to se- lect the phase of subwoofer output. Touch d to select normal phase and Normal appears in the display. Touch c to select re- verse phase and Reverse appears in the dis- play.

Note

When playing a 2-channel mono source with Dolby Pro Logic II turned on, there may be occa- sions when the following will occur:

!No audio is outputted if the center speaker setting is Small or Large and no center speak- er is installed.

!Audio is heard only over the center speaker if installed and the center speaker setting is Small or Large.

Speaker level can be adjusted finely by listen- ing to an audio output. First, use test tone to adjust the approximate speaker level, and then use this function to adjust finely.

1Touch Speaker Level.

2Touch a or b to select the speaker to be adjusted.

Each time you touch aor b selects the speak- er in the following order:

Front-L (front speaker left)—Center (center speaker)—Front-R (front speaker right)— Rear-R (rear speaker right)—Rear-L (rear

speaker left)—Subwoofer (subwoofer)

# You cannot select speakers whose size is set to Off. (Refer to Setting the speaker setting on the previous page.)

3Touch c or d to adjust the speaker out- put level.

Each time you touch cor d it increases or de- creases the equalizer level. +10 to –10 is dis- played as the level is increased or decreased.

Note

To adjust the speaker output levels in this mode is the same as making the speaker output levels at Test Tone. Both provide the same results.

Selecting a cross-over frequency

You can select a frequency, under which sounds are reproduced through the subwoo- fer. If the installed speakers include one whose size has been set to Small, you can select a frequency, under which sounds are repro- duced through a Large speaker or subwoofer.

1Touch Cross Over.

2Touch a or b to select the speaker to be adjusted.

Each time you touch aor b selects the speak- er in the following order:

Available accessories

En 87