Appendix
Additional Information
iPod
Message | Cause | Action |
|
|
|
Communication failure | Disconnect the cable from iPod. Once iPod | |
|
| main menu is displayed, connect the cable |
|
| again. |
|
| Reset the iPod. |
|
|
|
| iPod failure | Disconnect the cable from iPod. Once iPod |
|
| main menu is displayed, connect the cable |
|
| again. |
|
| Reset the iPod. |
|
|
|
Old version of iPod | Update the iPod version. | |
|
|
|
No Songs | No songs | Transfer the songs to iPod. |
|
|
|
Stop | No songs in the current list | Select a list that contains the songs. |
|
|
|
Understanding auto TA and EQ error messages
When correct measurement of car interior acoustic characteristics is not possible using the auto TA and EQ, an error message may appear on the display. If an error message appears, refer to the table below to see what the problem is and the suggested method of correcting the problem. After checking, try again.
Message | Cause | Action |
|
|
|
Error. Please check MIC. | Microphone is not connected. | Plug the supplied microphone securely into |
|
| the jack. |
Error. Please check Front speaker., Error. Please check
The microphone cannot pick up the ! Confirm that the speakers are connected
measuring tone of a speaker. | correctly. |
| ! Correct the input level setting of the power |
| amp connected to the speakers. |
| ! Set the microphone correctly. |
Error. Please check noise. | The surrounding noise level is too | ! Stop your car in a place that is as quiet as |
| high. | possible, and switch off the engine, air condi- |
|
| tioner or heater. |
|
| ! Set the microphone correctly. |
|
|
|
98 En