Section
19Available accessories
Carrying out auto TA and EQ
1Stop the car in a place that is as quiet as possible, close all doors, windows and the sun roof, and then turn the engine off. If the engine is left running, engine noise may prevent correct auto TA and EQ.
2Fix the supplied microphone in the cen- ter of the headrest of the driver’s seat, fa- cing forward, using the belt (sold separately).
The auto TA and EQ may differ depending on where you place the microphone. If desired, place the microphone on the front passenger seat to carry out auto TA and EQ.
3Turn the ignition switch to ON or ACC. If the car’s air conditioner or heater is turned on, turn it off. Noise from the fan in the air conditioner or heater may prevent correct auto
TA and EQ.
# Press SRC/OFF to turn the source on if this unit is turned off.
4Select the position for the seat on which the microphone is placed.
Refer to Using the position selector on page
# If no position is selected before you start auto TA and EQ,
5Touch the source icon and then touch Off to turn this unit off.
6Touch the screen to display the touch panel keys.
7 Touch AV Menu and then touch
Initial Menu to display the function names.
8Touch Auto EQ&TA to enter the auto TA and EQ measurement mode.
9Plug the microphone into the micro- phone input jack on the
For details concerning operation, refer to the
10Touch Start to start the auto TA and EQ.
11Get out of the car and close the door within 10 seconds when the
The measurement tone (noise) is outputted from the speakers, and auto TA and EQ be-
gins.
# When all speakers are connected, auto TA
and EQ is completed in about nine minutes.
# To stop auto TA and EQ, touch Stop.
# To cancel auto TA and EQ on the way, touch Back or ESC.
12When auto TA and EQ is completed, Complete is displayed.
When correct measurement of car interior acoustic characteristics is not possible, an error message is displayed. (Refer to Under- standing auto TA and EQ error messages on page 98.)
13Touch ESC to cancel the auto TA and EQ mode.
92 En