Pioneer AVIC-90DVD installation manual Connecting the power cord

Connecting the System

Connecting the power cord (1)

Speed detection circuit lead

Car injection computer

Connector

Connection method

Pass the extension cord and the lead for the speed detection circuit through this hole.

Clamp firmly with needle-nosed pliers.

Close the cover.

Pink (CAR SPEED SIGNAL INPUT)

Note: The position of the speed detection circuit depends on the car model. For details, consult the rele- vant documents from Pioneer. When making connections for a model not listed in those docu- ments or for which connection to the speed detection circuit is too difficult, connect the separately sold ND-PG1 speed pulse genera- tor to the pink lead.

The navigation system is connected here to detect the distance the car travels. Always connect the car’s speed detection circuit or the ND-PG1 speed pulse generator, sold separately. Failure to make this connection will increase in the location display.

WARNING: IMPROPER CONNECTION MAY RESULT IN SERIOUS DAMAGE OR INJURY INCLUDING ELE- CRICAL SHOCK, AND INTERFERENCE WITH THE OPERATION OF THE CAR’S ANTILOCK BRAKING SYS- TEM, AUTOMATIC TRANSMISSION AND SPEEDMETER INDICATION.

Lightgreen

Note: The position of the parking brake switch depends on the car model. For details, consult the car owner’s manual or dealer.

Connection method

Used to detect the ON/OFF status of the parking brake. This lead must be connected to the power supply side of the parking brake switch. If this connection is made incorrectly or omitted, cer- tain functions of your navigation system will be unusable.

Clamp the parking brake switch power supply side lead.

Clamp firmly with	Power supply side
needle-nosed pliers.	Ground side

11

Parking brake switch