Pioneer AVR-W6100 owner manual Setting remote control code type

Using the Remote Control

Setting remote control code type

When the remote control operation switch is set to DVD, changing the remote control code type enable to operate the Pioneer DVD player by the supplied remote control. There are three remote codes, code type A, code type B and code type DVH.

When using this unit with “XDV-P9II” or “XDV-P9” Multi-DVD Players, select code A. When using this unit with a DVD Navigation Unit, select code B.

When using this unit only, select code DVH.

When using this unit with “SDV-P9” or “AVX-P7300DVD” DVD players, select code A or B. (Depending on reception signal setting of DVD player.)

1.Set the remote control selection switch on the left side of the remote control to appropriate position with a pen tip or other pointed instrument .

•If you selected DVH mode, there is no need to operate the following procedure.

•If you selected A/B mode, read the following procedure and change the code type into the appropriate one.

2.Pressing 7 and 0 on the remote control simultaneously changes the code type.

Initially, code type is set to A.

Each time you press 7 and 0 on the remote control simultaneously changes the code type between A and B.

9