Dakota Digital 3 operation manual Series, NOW with Solid State Sensor Technology

Page 1

VACUUM FLUORESCENT DIGITAL DASHBOARD

SERIES 3

NOW WITH

SOLID STATE SENSOR TECHNOLOGY

INSTALLATION AND OPERATION MANUAL

Please read this before beginning installation or wiring.

IMPORTANT NOTE!

This system has an odometer preset option that is only

available for the first 100 miles (160km) of operation. See odometer preset section for instructions and setup information.

1

MAN 650066:D

Image 1
Contents NOW with Solid State Sensor Technology SeriesTypical Display Setups Mounting Systems with Displays Mounted to Aluminum Mounting Universal Display Systems with SubpanelsMounting Single Lens Systems Complete Systems mounted in new bezel Mounting Kits Into Original DashesGauge System Features Description Message DisplaysControl BOX Mounting Wiring the control box into the vehicleStatus LED Terminal DescriptionsGround Tach PowerWarn DIMSPD SND SPD +SPD SPD OUTADJ SND SW 1 or Speed switchADJ WTR SNDOIL + WTROIL SND OILFuel Fuel SNDCruise Wait +Brake Right +AUX. I/O Check ENGDisplay Ribbon Cable Setting up the control box Speed sensor setup Sender Speedometer SETUP/CALIBRATIONMAN 650066D Exit setup Done Tachometer SetupEngine cylinder setup T-CAL Speed Output OutputDisplay update setup Update Volt SetupRpm warning setup Warn Tach signal setup SignalTemp sensor setup Sender Water Temp SetupTemp warning setup Warn Exit water temp setup Done OIL Pressure SetupOil pressure warning setup Warn Temp sensor test TestExit oil pressure setup Done Fuel SetupOil pressure sensor test Test Fuel sensor setup Sender Nighttime DIM Setup Performance Menu SetupExit fuel setup Done Odometer Preset Menu BUS Interface Module SetupInformation Menu Troubleshooting Guide MAN 650066D MAN 650066D Clock Instructions For VFD systems with a clock built Troubleshooting guide Service and Repair