Gauge System Features

Mileage readings

∙Million mile odometer

∙Two (A/B) re-settable trip mileage (0-9999.9)

∙Re-settable service mileage (0-9999) Performance readings

∙High speed recall. This is reset at power up and can be manually reset.

∙High rpm recall. This is reset at power up and can be manually reset.

∙0-60 mph (0-100kmh) time.

∙¼ mile time.

∙¼ mile end speed. This is reset when the ¼ mile time restarts.

Hour meter

∙Resettable hours (0-999.9) English/metric conversion

∙Alternate speed can be displayed on message display. Special tachometer displays

∙On systems that do not have bar graph displays, a bar tach can be shown on the message display.

∙On systems that do not have a digital tachometer display, the rpm can be shown on the message display or the tachometer reading can be switched onto the speed display.

Built-in Indicators

∙Left/Right Turn signal indicators

∙High Beam indicator

∙Check Engine indicator

∙Brake warning indicator

∙4x4 indicator

∙Wait to Start indicator

∙Cruise control indicator

∙Gear position indicator which displays full gear word with use of Dakota Digital GSS-2000(purchased separately)

Special outputs

∙Shift output to activate external light

∙Selectable 2000ppm or 4000ppm speed output for cruise or ECM

Demonstration mode

∙Holding Switch 2 while turning on the key will start the system going through a preset sequence of readings. To exit the demo mode, turn the key off. You may also wire up a separate switch to power the gauges for demo mode without powering the entire vehicle.

Auxiliary gauge readings in tach message display with future expansion bus interface modules (BIM)

5	MAN 650066:D