Technicolor - Thomson EZCRG owner manual Playing a video game, Sending AV signals Refer to Figure

Page 9

has accumulated inside of VCP. In this case, the VCP will not operate, and no VCP controls will be functional, except for the VCP power button on the remote control, until the unit dries out sufficiently and the word DEW disappears from the screen. When DEW mode has been activated, leave the VCP on to allow it to dry out completely. This will take approximately 1 hour.

K. Playing a video game

Plug the video output from your game into the yellow video jack, and the audio L and audio R into the corresponding audio jacks.

L. Sending AV signals (Refer to Figure 3)

To send AV signals from this floor console to an external monitor, connect the AV output jacks on the rear of the console to the external monitor input jacks, after opening the rear door.

M. Using a Headphone

Inserting the plug of your headphone to the number 2 headphone jack on the front of the floor console permits both speaker and headset sound simultaneously. Using the number 1 headphone jack cuts off (mutes) the speaker audio.

N. Remote Control Operation (Refer to Figure 4)

Figure 4

9

Image 9
Contents Ezcrg Introduction PrecautionPage Tools Required not supplied Contents in KitPage Page Detail Connecting an External Antenna Refer to Figure Watching TVWatching a Movie Using a Headphone Sending AV signals Refer to FigureRemote Control Operation Refer to Figure Playing a video gameVCP Power Button TV Power ButtonSKIP/SEARCH Button TV/CATV ButtonCH Up Button TV/VIDEO ButtonCH Down Button VOL Up ButtonNtsc Specifications System