Sanus Systems LA112 manual 6901-100189

Page 4

CauTION

Avoid potential injuries or damage to equipment. The LA112 is designed to mount to vertical walls only. Do not attempt to mount the LA112 to ceilings or non-vertical walls. For indoor use only! Do not mount outdoors.

CauTION

Avoid potential injuries or damage to equipment! Always observe the LA112 while in motion. To stop the motion, press any of the arrow keys on the remote control. Never allow children to operate the LA112.

CauTION

Avoid potential injuries or damage to equipment! Do not operate the LA112 unless all protective covers and guards are in place. Keep away from moving parts.

CauTION

Avoid damage to equipment! Use only accessories distributed or recommended by Sanus Systems. Do not operate the LA112 if the appliance has malfunctioned, or has been damaged in any way; return to an authorized service facility for inspection.

CauTION

Avoid potential injuries or damage to equipment! The LA112 must be connected to a grounded outlet. Disconnect the LA112 when not in use, or before cleaning or servicing the unit. To disconnect the LA112, turn off all controls then remove the plug from the outlet.

CauTION

Do not unplug by pulling on cord. To uplug, grasp the plug, not the cord.

6901-100189 <01>

Page 3 Page 5
Image 4
Page 3 Page 5
Contents LA112 Backed by CLOMeasure width between holes Supplied Parts and HardwareMeasure height between holes 01 x 02 x 04 x 05 x 06 x 07 x10 x 11 x 12 x 08 x 14 x6901-100189 Remove Wall Plate from Arm Remove Mounting Brackets For Wood Stud Walls Mount Wall PlateMin .5 cm 2.5 For Concrete Block or Brick Walls Install Arm Assembly to Wall Plate Set the Monitor Width Selector SetTop Install Mounting Brackets18, 19 12, 13, 14, 15, 16 21, 22 For Power Outlets Located Outside the Bellows Route CablesFor Power Outlets Located Inside the Bellows Install Monitor to Wall Plate Reset the LA112 Home Position Adjust Monitor PositionCalibrate the Arm Calibrate Arm to the MonitorUsing the Remote Control CBL mode Page UpProgramming the Preset Position Keys PressProgramming the Remote to Operate an Existing TV TV Programming Codes Programming CodesTV Brand Code Numbers NEC SSSTMK RCADVD Programming Codes DVD Brand Code NumbersJVC KLHVCR Programming Codes VCR Brand Code NumbersTeac STSFor Cable Boxes Brand Code NumbersTroubleshooting How to CorrectArm Will Not Move A1,A2, or A3 is displayed on control boxPower Switch Control Box LED Display Selector Set Button C1,C2,C3 or C4 is displayed on control boxHC is displayed on control box H1,H2, or H3 is displayed on control box Maintenance If Your TV Leans Forward at the Home PositionHome Automation Controls Warranty Purchaser InformationProduct Information To register by mail
Top Page Image Contents