Sanus Systems LA112 manual Remove Mounting Brackets

Page 6

2: Remove Mounting Brackets

[27]

You must remove the two TV Mounting Brackets from the LA112 before attaching the arm to the wall plate.

Remove the hex screws [A] from the mounting brackets [03]. Pull the safety clips [04] from the back of the mounting brackets, then remove the mounting brackets from the arm assembly.

[A]

[27]

[04]

[03]

6901-100189 <01>

Image 6

Contents LA112 Backed by CLOSupplied Parts and Hardware Measure width between holesMeasure height between holes 10 x 11 x 12 x 08 x 01 x 02 x 04 x05 x 06 x 07 x 14 x6901-100189 Remove Wall Plate from Arm Remove Mounting Brackets Mount Wall Plate For Wood Stud WallsMin .5 cm 2.5 For Concrete Block or Brick Walls Install Arm Assembly to Wall Plate Set the Monitor Width Selector SetInstall Mounting Brackets Top18, 19 12, 13, 14, 15, 16 21, 22 For Power Outlets Located Outside the Bellows Route CablesFor Power Outlets Located Inside the Bellows Install Monitor to Wall Plate Calibrate the Arm Reset the LA112 Home PositionAdjust Monitor Position Calibrate Arm to the MonitorUsing the Remote Control CBL mode Page UpProgramming the Preset Position Keys PressProgramming the Remote to Operate an Existing TV Programming Codes TV Programming CodesTV Brand Code Numbers TMK NECSSS RCAJVC DVD Programming CodesDVD Brand Code Numbers KLHVCR Programming Codes VCR Brand Code NumbersTeac STSFor Cable Boxes Brand Code NumbersArm Will Not Move TroubleshootingHow to Correct A1,A2, or A3 is displayed on control boxPower Switch Control Box LED Display Selector Set Button C1,C2,C3 or C4 is displayed on control boxHC is displayed on control box H1,H2, or H3 is displayed on control box Maintenance If Your TV Leans Forward at the Home PositionHome Automation Controls Product Information WarrantyPurchaser Information To register by mail