2-4 Controls and operation
Source tone memory
Bass and Treble positions are automatically memorised for AM radio, FM radio, cassette tape and CD/MD, allowing individual settings for each mode.
Change audio system source
Press the desired audio system source button.
Band Switch AM/FM
Pressing AM/FM repeatedly will cycle the radio through FM. Band selection will be shown in the display panel. When a tape or CD/MD is being played, pressing the band switch will select radio operation.
Presetting memorised radio stations
!WARNING:
In the interests of road safety, do not attempt to preset a station while driving.
On each waveband, nine stations can be memorised using keypad buttons 1 to 9. After tuning to a station, press and hold the selected button until the unit ‘beeps’. A station can be recalled from the preset memory by pressing and immediately releasing the button. Pressing the steering wheel preset selector button will cycle through the preset stations.
Seek and manual tuning
In AM/FM mode, pressing and releasing the left or right button will activate the radio in seek mode, tuning through the frequency range to the next available station. Pressing either button for more than two seconds will enter manual tuning mode.
Auto memory (A MEM)
The automatic memory function programmes the nine strongest stations on a selected waveband to presets 1 to 9.
Note: These are additional to the preset stations described earlier.
To activate this function, press and hold A MEM button for at least two seconds.
The radio will be briefly muted while it searches the waveband for the nine strongest stations. When programming is complete the radio will default to preset number 1 and audio volume is restored.