Jaguar JJM 18 03 24/22 manual Radio set up, Preset

Page 20

Controls and operation 2-13

Radio set up

This function enables the radio to be set to user operating preferences. By selecting SET UP and using the preset buttons, the owner or Jaguar Dealer can adjust certain radio functions.

When in SET UP, pressing the relevant preset button, as detailed below, will display the facility selected and its state. The state of that facility can be changed by pressing the preset button again.

To enter SET UP: Press Tape Eject and AM/FM buttons simultaneously.

The display will show SET UP. The following preferences can then be selected or changed in any order, within a 15 second period. After 15 seconds the display will clear and exit SET UP.

Preset 1 Press Preset 1 to enable or disable RBDS,

 

depending upon RBDS availability in the user’s

 

country.

Preset 2 On cassette tape models, this controls the

 

Tape Clean reminder facility. To switch off this

 

reminder, press the Preset 2 button until

 

TAPE CLN OFF shows on the display.

Preset 3

Blank.

Preset 4

Blank.

Preset 5 KEY OFF EJECT – On cassette tape models,

 

this sets the cassette tape to automatically eject

 

when the ignition key is turned to 0.

Preset 6

Blank.

Preset 7

Blank.

Preset 8

Blank.

Preset 9

Blank.

Preset 0

During initial factory installation, this is used to set

 

the radio to the USA region. Regional settings

 

determine the correct frequency increments

 

required for seeking stations, automatic tuning etc.

 

Note: The regions are preset at the factory.

 

Should you require a regional change, consult your

 

Jaguar Dealer.

Image 20
Contents 2002MY NAS Audio System Handbook Foreword Audio System Handbook Jaguar Cars LIMITED, as manufacturer, isContents Introduction General informationCassette tape model controls Single CD model and MiniDisc MD model controls Page Steering wheel controls where Audio system display panel in AM/FM modeControls and operation Radio operation DSP Setting Seating Positions Setting the audio display clockBand Switch AM/FM Seek and manual tuningSource tone memory Change audio system sourceRbds operation MEM with radio broadcast data system Rbds selectedRadio broadcast data system Rbds PTY31-Alarm where broadcast Programme type PTYPriority programme type Ppty Priority PTY interrupt skipRbds trouble-shooting guide Incorrect response from Rbds Reason and rectificationSingle CD player operation Seek up and down Eject and MD-in indicator MiniDisc MD operationLoading MD Ejecting MDControls and operation Cassette tape player operation Radio set up PresetLoading discs and inserting magazine Compact disc CD changerCD check sequence CD changer mode CDC buttonMIX and CD MIX No Magazine In the CD autochangerPause System care Audio system careRadio CassettesPage Index Index JJM 18 03 24/22