Instructions General Operation | Blaupunkt CM147 guide

Instructions — General Operation

See Traffic Safety & Precautions on page 4.

“Press” means a momentary press of less than 1/2 second. All presses requiring more than 1/2 second are followed by beep. (Beep for all button presses available through Direct Software Control Menu.)

“Time Out” When additional button presses are anticipated to complete a procedure, the unit will automatically exit the procedure after 4 seconds of inactivity. (8 for Menu mode.)

Ignition-Off Clock Recall

Any button press while ignition off displays time for 8 seconds.

Ignition-On

Unit lights up and clock is displayed.

Demo Mode

The unit is programmed to scroll some key features across the display if no button is presses for one minute . (You may have seen this at the store where you purchased your radio.) TO TURN THIS OFF, turn the unit on and press DIS for 8 seconds until “DEMO OFF” appears. (Pressing DIS for 8 seconds again will re-activate this feature.)

Release for Detachable Faceplate

Push REL to detach face. Already-inserted cassette remains in unit. Current settings and source mode are stored, except when detach occurs during Menu mode, new Menu settings are not stored. If power was not switched off before face removed, unit will automatically power-on when face is reattached.

Power (PWR) On

When ignition on, press PWR or insert a tape to turn unit on. Last-used source becomes active, unless unit is turned on by inserting cassette, in which case cassette player becomes active. Display sequence at Power-On:

1.Turn-On Message (To turn message off or modify message, see Menu, page 20.)

2.“RADIO”,“TAPE”, CHANGER”, or “AUX IN”.

3.Functional information sequence (See Display Options, below.)

4.Priority display for active source.

Display Options

Press DIS to change information shown at times when no manual or automatic activity takes place. Choice of priority display is separate for each audio source:

Radio: Station Name (if named) —> Frequency —> Clock

Cassette: “TAPE” (1 or 2) –> Clock

CDC: Disc Name (if named) or Disc No.–>Disc No./Track No.–>Track No./Elapsed Play Time–>Clock

AUX : “AUX IN” —> Clock

After a change in source, radio station or changer discs, the current source’s non-clock displays are shown in sequence, then display returns to current source’s priority display.

Source (SRC)

Use SRC to select source - radio or cassette (if already inserted,) CD Changer (if connected) and/ or auxiliary input (even if no input on aux in line) as per model’s features.

Power Off

Press PWR for more than 1/2 second to turn unit off. Unit stores current settings for source, station or track, etc. Antenna and amplifier trigger wires shut off voltage. (If faceplate still attached, display switches to clock.)