FM and AM Buttons
Press FM to access last active FM bank. When in FM radio mode, press of FM advances to next FM band, FM1, FM2, or FM3/FMT. When in AM mode or other source, pressing FM button returns to
Seek Tuning
Press /\ or V to seek next receivable frequency. Tuning stops at frequency that fulfills sensitivity requirements predetermined by sensitivity set through SENS/LD button. Press of /\ or V buttons for more than 1/2 second seeks next receivable frequency after button is released.
Tuning Sensitivity (SENS)
Press SENS/LD for more that 2 seconds to switch between LO (Local) and DX (Distant) search sensitivity
Radio Reception Hints
•When listening to weak or distant AM stations, adjusting the Treble to minimum
•In general, set SENS to DX if in rural areas or where stations tend to be weak and distant, and to LO when in metropolitan areas or where stations tend to be strong and local.
Stereo Symbol
Stereo symbol turns on if a stereo station with an incoming signal of 20 dBμV is received. The unit gradually switches between mono to stereo automatically.
Manual Tuning
Press << or >> and frequency will go one channel/step in direction pressed. Press and hold causes continuous manual tuning.
Preset Station Storage
After tuning desired frequency on desired band, press and hold a Preset Button for more than 2 seconds to store current frequency. Audio is muted during storage, preset number appears, and beep acknowledges storage. No preset storage during seek, scan or Travel Store.
Preset Station Selection
Press desired Preset Button.
Travel Store
This feature allows you to automatically store stations onto all 6 preset buttons and is especially useful when traveling outside your normal listening area. In any FM Bank, press FM Button for 2 seconds to activate FM Travel Store. (In AM Bank, press AM Button for 2 seconds to activate AM Travel Store.) T STORE appears, followed by
Station Scan Tuning
Press SCA. “STA SCAN” appears, then frequency blinks (along with preset number if appropriate) during scanning. Unit stops at receivable stations for scan time set under Menu. Unit continuously scans until user stops scan by pressing SCA, another tuning button, SRC, or MENU button.
Preset Scan Tuning
Press PS/SCA for more than 2 seconds. “PS SCAN” appears, then frequency and preset number blink during scanning. Unit starts at FM1/Preset 1 (or AM/Preset 1) and proceeds through all presets (in FM all three banks) and returns to frequency tuned prior to PS activation and stops. Stops earlier if user presses another tuning button, SCA, SRC, or MENU button. Unit skips past preset frequencies that do not meet minimal
Tuner Timer and Station Naming (See pages 20 and 21)
16