Lost or damaged KeyCards

THEFT PROTECTION

To “train” a new KeyCard as a replacement for a lost or unusable KeyCard:

➮Insert the remaining valid KeyCard and switch on the unit.

➮Press the MENU button 8.

➮Press the soft key 4 with the display allocation “KC”.

➮Press the soft key 4 with the display allocation “LRN”.

The display will read “LEARN KC”.

➮Remove the first KeyCard. The display will read “INSERT”.

➮Insert the new KeyCard.

The display will read “LEARN OK”.

To exit the KeyCard menu

➮press the MENU button 8 or the OK button 5.

Now the car radio can be used with two Key- Cards again.

If all of the KeyCards belonging to a unit have been lost or damaged, first a new KeyCard with the master code of the unit must be “trained”. The master code of the unit is con- tained in the radio pass.

Always keep the radio pass in a safe place, but never in your vehicle.

To “train” a new KeyCard, follow the instruc- tions given in the section “Training a new Key- Card / entering the master code”.

If necessary, you can use this KeyCard to train a second KeyCard. For instructions on how to do this, read the section “Replacing / train- ing KeyCards”.

New KeyCards can be obtained from your dealer.

“Training” a new KeyCard / entering the master code

If you no longer have any valid KeyCards for your unit and want to “train” a new KeyCard:

➮Insert a new KeyCard that is unknown to the unit.

➮Close the operating panel.

➮Turn off the unit if necessary.

➮Simultaneously hold down the TUNE button > and the second soft key 4 from the top on the left side 2.

The display will read “0000”.

Enter the four-digit master code from the ra- dio pass as follows:

➮Use the / buttons 7 to enter the respective digits of the master code. Press the buttons until the desired num- ber appears on the display.

➮Use the buttons 7to move from one digit to the next during input.

➮Once the master code is displayed cor- rectly, press the OK button 5.

The new KeyCard is accepted when the unit switches to play.

Optical theft protection indicator (LED)

The ON/OFF button and the CD bay illumi- nation can be set to blink when the unit is off and the KeyCard has been removed. To do this, the menu setting “LED” must be set to “ON”.

➮Press the MENU button 8.

➮Press the soft key 4 with the display allocation “KC”.

➮Press the soft key 4 with the display allocation “LED”.

The display will show the current status “LED ON” or “LED OFF”.