•press AF as many times until the de- sired setting is displayed.
•Hold down the AF button until you hear a beep.
SCAN operation
Use this function to scan all of the CD tracks.
To start the Scan function:
•Press SC.
The titles will be scanned one after the oth- er in ascending order.
To stop the Scan function:
•Press SC.
The track currently being scanned is con- tinued to be played.
SCAN will also be terminated by
•pressing one of the buttons AUD, GEO, DSC, SRC, 
, << >> or 
/
.
DSC programming
DSC (Direct Software Control) allows you to customise certain programmable, basic settings to suit your personal needs and preferences and then store them.
The basic settings for this audio equipment were made at the factory.
In the following you can find an overview of these settings, so that you can always reset to these if desired.
If you wish to alter any of the programming,
•press DSC.
Use the rocker switch and the 
button to select and adjust the functions described in the following. The display will show you the adjusted condition.
LOUDNESS Loudness - When listening at a low level, the Loudness function creates a more nat- ural sound by boosting the low frequency range. LOUD 1 - Low boost LOUD 6 - Max. boost
TA VOL To adjust the traffic an- nouncement and warning beep volume from between 0 to 63.
The message will then come through at this volume, if the standard volume is lower.
Should the standard volume be higher than the TA VOL level, then the traffic report will be played slightly louder than the standard volume.
/
Select function
<<>> Adjust/recall value
42