Blaupunkt RD 126 operating instructions Quick reference, Fmt

Page 4

Quick reference

1Switching on/off with the ON button: Press ON.

When switching the set on with the ON button, the KeyCard has to be insert- ed. The unit will play with the pre-ad- justed volume.

Switching on/off with the KeyCard: The set has to be turned on via the ON button.

Note:

Read the information in chapter “KeyCard theft protection system”.

Switching on/off via the ignition:

When connected correspondingly, the set can also be turned on and off via the vehicle ignition.

After the ignition has been switched off, a double beep tone will remind you that you should remove the KeyCard before leaving your vehicle.

Switching on with the ignition being switched off:

To keep on operating the set when the ignition is switched off (KeyCard is in- serted), proceed as follows:

Press ON after the double beep tone. The unit will be turned on.

To avoid that the battery goes flat, the system will be turned off automatically after a playback time of one hour.

2VOL+ / VOL-

To alter the volume.

Each time the set is switched on, it will play with the pre-adjusted volume (VOL FIX).

You may also change the VOL FIX set- ting (see chapter “DSC programming”).

3

For instantly muting the volume.

By pressing the button the volume will be muted immediately. “MUTE” will appear in the display.

The function is cancelled by pressing button or VOL+.

When pressing VOL-, the normal vol- ume will be by one grade lower than the mute volume.

To programme the mute volume level, proceed as follows:

Adjust the desired volume.

Press for two seconds until you hear a beep.

Now this volume level is stored as your mute volume.

Extra function

Memory button in the DSC menu.

4FMT

Press repeatedly to switch between the FM memory banks I, II and T (Travelstore).

When pressing this button, the system will automatically switch to FM.

Extra function FMT

To store the six most powerful stations automatically with Travelstore:

Press FMT until you hear a beep or “T-STORE” appears in the display. The storage process is finished when “T- STORE” disappears from the display.

5M•L - toggle switch

To toggle between medium and long wave reception.

26

Image 4
Contents Sevilla 10 11 Contents Quick reference FMTRocker switch Radio operation Extra rocker switch functionsAUD D GEO C DSC Mode B PTY DisplayPreset Scan Flashing KeyCard tongueMIX Scan@ 1, 2, 3, 4, 5, 6 preset buttons = AFSRC Source EjectGEO AUDExtra function GEO Extra function AUDPrecautions Installation Accessories Traffic safetyImportant notes Telephone muteKeyCard theft protection system Removing the KeyCardReplacing a KeyCard Never pull out the KeyCard directlySwitching off the flashlight Short Additional Memory S.A.MTurn On Message T.O.M Optical indication for extra security Care of your KeyCardRadio operation with RDS Radio Data System Manual tuning with Scrolling through the broadcast- ing networks only FMChanging the memory bank FM Storing stationsGest stations with Travelstore Preset Scan Selecting the seek tuning sensiChanging the scan time TivityProgramme type Switching from stereo to monoSport Scanning stations with PTY-SCAN Storing programme typesPTY priority Traffic announcement priority Receiving traffic programme stations with RDS-EONOn/off Automatic seek tuning start Adjusting GEO for traffic mes- sages and the warning beepSwitching the warning beep off To make a settingSelecting a title MIX playback Switching to CD operation Selecting the display modeStoring the display mode Inserting a CDScan operation DSC programmingTo stop the Scan function Angle Learn KCBright Read KCOverview of the DSC factory settings SpecificationsAppendix PTY LangBlaupunkt telephone hotline Blaupunkt-Werke GmbH