•After having updated the last CD or magazine, press TPM for approximate- ly two seconds (beep).
To quit the function,
•press DSC.
The system has saved the TPM information for all of the CDs which were inserted. For all other discs, the TPM information and CD names have been deleted.
DSC programming
DSC (Direct Software Control) allows you to customise certain programmable, basic settings to suit your personal needs and preferences and then store them.
The basic settings for this audio equipment were made at the factory.
In the following you can find an overview of these settings, so that you can always reset to these if desired.
If you wish to alter any of the programming,
•press DSC.
Use the rocker switch and the 
button to select and adjust the functions described in the following. The display will show you the adjusted condition.
/
Select function
<<>> Adjust/recall value
CD/CDC NAME
Only available for CD/CDC playback.
Use this function to name your CDs. (See “Entering CD names”).
LOUDNESS Loudness - When listening at a low level, the Loudness function creates a more nat- ural sound by boosting the low frequency range. LOUD 1 - Low boost LOUD 6 - Max. boost
TA VOL To adjust the traffic an- nouncement and warning beep volume from between 0 to 63.
The message will then come through at this volume, if the standard volume is lower.
Should the standard volume be higher than the TA VOL level, then the traffic report will be played slightly louder than the standard volume.
52