Warning note
Danger of damaging the motor antenna in a car wash
If you have installed a motor antenna, it will remain extracted when turning off the radio while the TIM timer is active.
The antenna may also come out inside the car wash when the set is turned off and the TIM timer active. This may cause serious damage!
Please read the next chapter for more infor- mation on how to interrupt the TIM standby mode temporarily before driving into a car wash.
Temporarily interrupting the TIM standby mode
(before driving into a car wash)
•Switch off the radio before driving into the car wash.
If the display goes out immediately, the TIM standby mode is inactive and the motor an- tenna is pulled in.
You can now drive into the car wash.
However, if “TIM ON” briefly shows on the display panel when turning off the set, the TIM standby mode is active.
•Press TIM.
The display briefly shows “STBY OFF”.
The antenna will be pulled in (please check) and will not be extracted until the unit is switched back on.
Now the TIM standby mode is temporarily inactive.
You can drive into the car wash.
The standby function will be automatically reactivated when switching the radio on again. The motor antenna will then come out.
Attention!
In order to prevent possible damage, do not switch on the radio until you have left the car wash!
DEUTSCH ENGLISH FRANÇAIS ITALIANO NEDERLANDS SVENSKA ESPAÑOL PORTUGUÊS
51