Blaupunkt RCR 126 Selecting a waveband, Scrolling through the broad- casting network only FM

Page 11

take advantage of the full RDS service, switch to “REG OFF”.

Press the REG button briefly.

When active, “REG ON” will be briefly dis- played each time the radio is switched on.

Selecting a waveband

With this car radio you can select between the following wavebands:

FM 87.5 - 108 MHz

MW 531 - 1602 kHz

LW 153 - 279 kHz

Select the desired waveband by pres- sing the FMT or M•L button.

To switch between MW and LW:

Press M•L.

Automatic tuning /

Press /; the car radio will automati- cally search for the next station.

When keeping the upper or lower part / of the rocker switch depressed, seek tuning will speed up in upwards or downwards direc- tion.

Automatic tuning

Up

Down

/ Up/down in short intervals (“AF” must be switched off)

/ To scroll through the broadcasting network when “AF” is activated (e.g. NDR1 ... NDR4).

Manual tuning << >>

(prerequisite: AF is switched off!)

Press << >>; the frequency will change in short intervals in downwards or up- wards direction.

When holding the right or left part of the rocker switch pressed down, the frequency scan is speeded up.

Scrolling through the broad- casting network (only FM)

You can use the << >> buttons to tune in stations of your reception area.

If several programmes of one broadcasting network can be received, you can scroll through them in forwards direction pressing

>>, or backwards using the << button, e.g. NDR 1, 2, 3, 4, N-JOY (North German broad- caster).

For this it is necessary that the stations have been received at least once and that “AF” has been activated before (lights up in the dis- play).

For this purpose, you may start Travelstore seek operation:

Press FMT for 2 seconds; the system starts to run through the frequency band.

If “AF” does not light up,

press AF.

With this, the requirements for selecting sta- tions with << >> are fulfilled.

Changing the memory bank (FM)

You can shift between the memory banks I, II and T in order to store stations and recall them later.

The currently selected memory bank is indi- cated in the display.

Press the FMT button as many times until the desired memory bank lights up in the display.

26

Image 11
Contents Bologna RCR Deutsch Contents Short instructions On Off VolumeTo alter a setting Adjusted value is indicatedTape operation Lo/dxDisplay Radio operation= PS 3, 4, 5, 6 preset buttonsTo switch over Prog button/Fast windingImportant notes PrecautionsTraffic safety Security code Installation/ConnectionAnti-theft protection Release panelRe-start following an interrup Tion of the power supplySwitching on security coding Switching off security codingAF Alternative frequency Radio operation with RDS Radio Data SystemREG regional programme Scrolling through the broad- casting network only FM Automatic tuningManual tuning Selecting a wavebandRecalling stored stations To start Preset ScanStoring stations To start the scan Selecting the seek tuning sensi- tivitySwitching from stereo to mono FM Scanning stations with Radio-ScanReceiving traffic programme stations with RDS-EON Automatic seek tuning startSwitching the warning beep off To switch the warning beep off, proceed as described aboveProg selector Tape operationInserting a tape Fast Forward/RewindLED code DSC programmingCare notes Overview of the DSC factory settingsSpecifications AppendixBlaupunkt-Werke GmbH
Related manuals
Manual 16 pages 11.75 Kb