Scanning stations with
Radio-Scan
Beginning with the station currently tuned in, you can scan the waveband. The radio will play each station for 8 seconds.
To start the scan:
•Press SC briefly.
The scanned frequency or the station name will start flashing in the display. During the actual scanning process “SCAN” will be displayed.
To select a station currently being scan- ned and switch off the scan function:
•Press SC briefly.
If no station is selected, the scan function will be automatically switched off after the fre- quency band has been run through comple- tely. The unit will tune in the station listened to before starting the scan.
Selecting the seek tuning sensi- tivity
You can alter the automatic seek tuning sensitivity.
If “lo” is displayed, the radio will only pick up strong, local stations (low sensitivity).
If “lo” does not light up, the radio will also pick up weaker, distant stations (high sensitivity). To switch over,
•Press lo or dx.
On top of this, the sensitivity levels can be adjusted separately for lo and dx (see chap- ter “DSC programming”).
Switching from stereo to mono (FM)
If reception is poor, you may get better sound quality by switching to mono:
•Press the lo button for approximately 2 seconds.
With mono playback, the stereo sign 
will disappear from the display.
Each time the radio is switched on, stereo playback is activated.
The unit will automatically switch to mono if the received signal is not strong enough for stereo playback.
28