Blaupunkt RCR 126 operating instructions Short instructions, On Off Volume, To alter a setting

Page 4

Short instructions

1On Off Volume

This unit can also be switched on and off with the Release Panel B.

Also, when being connected correctly, you may turn the radio on and off via the ignition of your car.

Use one of the following possibilities to continue operating the set when the ignition is switched off:

a)Switch on/off with knob 1.

b)Remove/re-install the release panel.

c)Press AUD 3.

When turning on the unit with the re- lease panel or by pressing the AUD button, the system will start to play with the volume adjusted last.

When operating the unit with the igniti- on being switched off, the system will automatically shut down after one hour in order to avoid that the battery goes flat.

2LD

Loudness - When listening at a low level, the Loudness function creates a more natural sound by boosting the low frequency range.

To switch the Loudness on/off: Press LD.

For more information, read chapter “DSC programming”.

3AUD/GEO AUD –

To adjust the treble and bass frequen- cies with the rocker switch.

Treble +

Treble

Bass

Bass +

GEO –

 

DEUTSCH

 

 

To adjust the balance (left/right) and

 

 

fader (front/rear) with the rocker switch.

 

 

 

ENGLISH

 

 

 

 

 

 

 

 

Fader front

FRANÇAIS

 

Fader rear

 

Balance left

 

Balance right

ITALIANO

To alter a setting,

 

• press AUD or GEO and then chan-

 

ge the value with the rocker switch.

 

 

NEDERLANDS

The adjusted value is indicated in the

 

display.

 

The last setting will be stored automati-

 

cally.

 

 

To finish the setting: Press AUD or

SVENSKA

GEO.

 

If the setting remains unchanged within

 

8 seconds, the display will switch back

 

to the previous condition.

 

ESPAÑOL

 

 

 

 

 

 

 

 

 

 

PORTUGUÊS

 

 

 

19

Image 4
Contents Bologna RCR Deutsch Contents On Off Volume To alter a settingAdjusted value is indicated Short instructionsLo/dx DisplayRadio operation Tape operation3, 4, 5, 6 preset buttons To switch overProg button/Fast winding = PSTraffic safety PrecautionsImportant notes Installation/Connection Anti-theft protectionRelease panel Security codeTion of the power supply Switching on security codingSwitching off security coding Re-start following an interrupREG regional programme Radio operation with RDS Radio Data SystemAF Alternative frequency Automatic tuning Manual tuningSelecting a waveband Scrolling through the broad- casting network only FMStoring stations To start Preset ScanRecalling stored stations Selecting the seek tuning sensi- tivity Switching from stereo to mono FMScanning stations with Radio-Scan To start the scanAutomatic seek tuning start Switching the warning beep offTo switch the warning beep off, proceed as described above Receiving traffic programme stations with RDS-EONTape operation Inserting a tapeFast Forward/Rewind Prog selectorDSC programming LED codeOverview of the DSC factory settings SpecificationsAppendix Care notesBlaupunkt-Werke GmbH
Related manuals
Manual 16 pages 11.75 Kb