Accessories/ Installation Procedure
Connecting Wires to Terminals
Accessories
1
..........1
2
..........2
3
..........4
4
..........4
5
..........1
6
..........1
7
..........2
8
1 2
..........1
3
Installation Procedure
1.To prevent a short circuit, remove the key from the ignition and disconnect the - battery.
2.Make the proper input and output wire connections for each unit.
3.Connect the speaker wires of the wiring harness.
4.Connect the wiring harness wires in the following order: ground, battery, ignition.
5.Connect the wiring harness connector to the unit.
6.Install the unit in your car.
7.Reconnect the - battery.
8.Press the reset button.
2WARNING
If you connect the ignition wire (red) and the battery wire (yellow) to the car chassis (ground), you may cause a short circuit, that in turn may start a fire. Always connect those wires to the power source running through the fuse box.
•If your car’s ignition does not have an ACC position, connect the ignition wires to a power source that can be turned on and off with the ignition key. If you connect the ignition wire to a power source with a constant voltage supply, as with battery wires, the battery may die.
•If the console has a lid, make sure to install the unit so that the faceplate will not hit the lid when closing and opening.
•If the fuse blows, first make sure the wires aren’t touching to cause a short circuit, then replace the old fuse with one with the same rating.
•Insulate unconnected wires with vinyl tape or other similar material. To prevent a short circuit, do not remove the caps on the ends of the unconnected wires or the terminals.
•Connect the speaker wires correctly to the terminals to which they correspond. The unit may be damaged or fail to work if you share the - wires or ground them to any metal part in the car.
•When only two speakers are being connected to the system, connect the connectors either to both the front output terminals or to both the rear output terminals (do not mix front and rear). For example, if you connect the + connector of the left speaker to a front output terminal, do not connect the - connector to a rear output terminal.
•After the unit is installed, check whether the brake lamps, blinkers, wipers, etc. on the car are working properly.
•Mount the unit so that the mounting angle is 30° or less.
| Ez900HDS/Ez700SR | Left output (White), Right output (Red) |
| ||
A | Aux input |
| |||
|
|
| See next page for Mounting | ||
B | Rear output |
|
|
| |
A | AUX IN |
| the SIRIUS Antenna. | ||
C | Front output |
| |||
| Sirius antenna | ||||
D Subwoofer output |
|
| |||
B |
|
| (Accessory8) | ||
|
|
| • Do not bend Sirius | ||
|
| REAR | Sirius antenna input | ||
|
|
| antenna input code | ||
C | FRONT | strongly. |
| • Connection part is | |
|
| |
D | SUB WOOFER | fixed on vinyl tape so |
that Sirius antenna is | ||
To KENWOOD disc changer/ |
| does not come out. |
External optional accessory |
| |
|
|
To connect these leads, refer to
the relevant instruction manuals.
Fuse (10A)
If no connections are made, do not let the wire come out from the tab.
When using the optional power amplifier, connect |
| |
to its power control terminal. | P.CONT | |
Depending on what antenna you are using, connect |
| |
either to the control terminal of the motor antenna, or to | ANT | |
the power terminal for the booster amplifier of the film- | ||
CONT | ||
type antenna. |
| |
Connect to the terminal that is grounded when either |
| |
the telephone rings or during conversation. |
| |
To connect the KENWOOD navigation system, | MUTE | |
consult your navigation manual. |
| |
To "EXT.AMP.CONT." terminal of the amplifier having the |
| |
external amp control function. |
| |
To car light control switch |
| |
To front left speaker | White/Black | |
| White | |
To front right speaker | Gray/Black | |
| Gray |
FM/AM antenna input
Wiring harness (Accessory1)
Power control wire (Blue/White)
Motor antenna control wire (Blue)
TEL mute wire (Brown)
External amplifier control wire (Pink / Black)
Dimmer control wire (Orange / White)
FRONT L
FRONT R
To rear left speaker | Green/Black |
| REAR L |
| Green |
To rear right speaker | Purple/Black |
| REAR R |
| Purple |
Ignition key switch
Car fuse box (Main fuse)
Battery + | – |
Car fuse box
ACC | Ignition wire (Red) |
| Battery wire (Yellow) |
Ground wire (Black) - (To car chassis)
36 English | English 37 |