Sound Setting
SOURCE/ | Rotary encoder (AUDIO/LOUD) |
BAND |
|
/ESC SOUND/SETUP
Adjusting Subwoofer Level/Bass Level/
Treble Level/Balance (Between Left and
Right)/Fader (Between Front and Rear)/
Defeat
1 Press Rotary encoder (AUDIO) repeatedly to
choose the desired mode.
Each press changes the mode as follows:
SUBWOOFER* 
BASS LEVEL 
TRE LEVEL 
BALANCE 
FADER 
DEFEAT 
VOLUME 
SUBWOOFER
Subwoofer : +0 ~ +15
Bass level:
Treble level:
Balance : L15 ~ R15
Fader : R15 ~ F15
Defeat : ON/OFF
Volume : 0 ~ 35
•If no operation is performed for 5 seconds after selecting the SUBWOOFER, BASS LEVEL, TRE LEVEL, BALANCE, FADER or DEFEAT mode, the unit automatically returns to normal mode.
*When the subwoofer mode is set to OFF, its level cannot be adjusted.
2 Turn the Rotary encoder until the desired sound is obtained in each mode.
By setting DEFEAT ON, previously adjusted settings of BASS LEVEL and TRE LEVEL will return to the factory defaults.
Setting the Bass Control
You can change the Bass Frequency emphasis to create your own tonal preference.
1 Press SOUND/SETUP repeatedly to select the BASS mode.
BASS 
TREBLE 
HPF 
BASS
Setting the Bass Center Frequency
80 Hz 
100 Hz 
200 Hz 
60 Hz 
80 Hz
Emphasizes the displayed bass frequency ranges.
Setting the Bass Bandwidth
2-2 Press SOURCE/
to select the desired bass bandwidth.
Changes the boosted bass bandwidth to wide or narrow. A wider setting will boost a wide range of frequencies above and below the center frequency. A narrower setting will boost only frequencies near the center frequency.
Setting the Bass Level
You can emphasize or weaken the bass level.
3 Press and hold 
/ESC for at least 2 seconds to return to normal mode.
•If no operation is performed for 15 seconds, the unit will return to normal mode automatically.
•The bass level settings will be individually memorized for each source (FM, AM, CD, etc.) until the setting is changed. The bass frequency and bass bandwidth settings adjusted for one source are effective for all other sources (FM, AM, CD, etc.).
•The function is inoperable when DEFEAT is set to ON.
*1 The adjustment can also be made by pressing Rotary encoder. Refer to “Adjusting Subwoofer Level/Bass Level/Treble Level/ Balance (Between Left and Right)/Fader (Between Front and Rear)/ Defeat” (page 12).