Audio
The sound is not output from the speakers.
•Unit has no output signal of the internal amplifier. - POWER IC is switched to “POW ON” (page 17).
iPod
iPod does not play and no sound is output.
•The iPod has not been recognized.
-Reset this unit and the iPod. Refer to “Initial System
Indication for CD Player
•No CD is inserted.
-Insert a CD.
•Although a disc is inserted, “NO DISC” is displayed and the unit does not start to play or eject the disc.
-Remove the disc by following these steps:
Press the button again for at least 2 seconds.
If the disc still does not eject, consult your Alpine dealer.
•Mechanism error.
1) Press the button and eject the CD.
If not ejecting, consult your Alpine dealer.
2) When the error indication remains after ejecting, press the button again.
If the error indication still does not turn off after pressing the button for a few times, consult your Alpine dealer.
•When “ERROR” is displayed:
If the disc cannot be ejected by pressing , press the RESET switch (refer to page 6) and press again.
If the disc still cannot be ejected, consult your Alpine dealer.
Indication for USB memory
•Abnormal current is run to the USB connector device (an error message may be displayed if the USB device that is not compatible with the unit is connected).
USB memory is a malfunction or it is shorted. - Connect another USB memory.
UNIT ERROR
•A USB device that is not supported by the unit is connected. - Connect a USB device that is supported by the unit.
NO DEVICE
•A USB memory is not connected.
-Make sure the USB memory device is correctly connected and the cable is not excessively bent.
•No song (file) is stored in the USB memory.
-Connect the USB memory device after storing songs (files).
•A sampling rate/bit rate not supported by the unit is used.
-Use a sampling rate/bit rate that is supported by the unit.
•A
-You can only play back
•A
-You can only play back
•A sampling rate/bit rate not supported by the unit is used.
-Use a sampling rate/bit rate that is supported by the unit.
NO SUPPORT
•Text information that is not recognizable by the unit has been input.
-Use a USB memory device with input text information that is supported by the unit.