Sound Skip Check Result Display Mode
This set can display the count of errors that occurred during the recording/playing for checking.
•Setting Method of Sound Skip Check Result Display Mode
1.Set the test mode (see page 15).
2.Press the N key or [REC] key, and the playing or recording sound skip result display mode becomes active respectively where the LCD displays the following.
Set LCD display
P**R**
|
|
|
|
|
| Total count of record |
|
|
|
|
|
| |
|
|
| 000 | system errors (hex.) | ||
|
|
|
|
|
| Total count of play |
|
|
|
|
|
| |
|
|
|
|
|
| system errors (hex.) |
3.When the N key is pressed, total error count is displayed on the LCD, and each time the > key is pressed, the display item moves down by one as shown below. Also, if the . key is pressed, the display item moves up by one, then if the [REC] key is pressed, the display in the record mode appears.
When the [REC] key is pressed, total error count is displayed on the LCD, and each time the > key is pressed, the dis- play item moves down by one as shown below. Also, if the . key is pressed, the display item moves up by one, then if the N key is pressed, the display in the play mode appears.
Playing sound skip | Recording sound skip |
result display | result display |
MZ-B10
• Cause of Sound Skip Error
| Cause of error | Description of error | |
|
|
| |
| EIB | Sound error correction error | |
|
|
| |
Play | Stat | Decoder status error | |
|
| ||
Adrs | Address access error | ||
| |||
| BEmp | Buffer is empty | |
|
|
| |
| BOvr | Buffer is full, and sounds were | |
| dumped | ||
|
| ||
|
|
| |
Record | Bful | Buffer capacity becomes less, | |
| and forcible writing occurred | ||
|
| ||
|
|
| |
| Rtry | Retry times over |
4.To quit the sound skip check result display mode and to return to the test mode (display check mode), press the x key.
• Setting Method of Key Check Mode
1.Set the test mode (see page 15).
2.Pressing the [TRACK MARK]key activates the key check mode.
Set LCD display
**
000
3.When each key on the set and on remote commander is pressed, its name is displayed on the set LCD. (Operated position is displayed for 4 seconds after the slide switch is operated.
Example: When the > key on the set is pressed:
Set LCD display
P**R**
000
EIB **
000
Stat**
000
Adrs**
000
BEmp**000
######000
P**R**
000
BOvr**
000
Bful**
000
Rtry**
000
######000
FF **
000
4.When all the keys on the set and on the remote commander are considered as OK, the following displays are shown.
Example: When the keys on the set are considered as OK:
Set LCD display
SET OK **
888
5.When the upper panel is opened, the key check mode quits and the test mode (display check mode) comes back.
P**R**: Total play/record errors (hex.)
**: Counter of sound skip check each item (hex.)
######:
19