Sony MZ-B10 service manual Reset the Error Display Code, Description of Error Indication Codes

MZ-B10

If the [GROUP] key or the [DISPLAY] key on the remote com- mander is pressed with this display, the LCD switches to the simple display mode.

4.Quit the self-diagnosis result display mode, and press the to return to the test mode (display check mode).

• Description of Error Indication Codes

x

key

Problem		Indication code	Meaning of code	Simple display	Description
No error		00	No error	---	No error
		01	Illegal access target	Adrs	Attempt to access an abnormal address
			address was specified
Servo system error		02	High temperature	Temp	High temperature detected
		03	Focus error	Fcus	Disordered focus or can not read an address
		04	Spindle error	Spdl	Abnormal rotation of disc
		11	TOC error	TOC	Faulty TOC contents
TOC error		12	Data reading error	Data	data could not be read at SYNC
		13	TOC address error	Tadr	TOC address data error
Power supply system error		22	Low battery	LBat	Momentary interruption detected
		31	Offset error	Ofst	Offset error
		32	Focus error ABCD	ABCD	Focus error ABCD offset error
			offset error
Offset system error		33	Tracking error	TE	Tracking error Offset error
			Offset error
		34	X1 tracking error	X1TE	X1 tracking error Offset error
			Offset error
		35	MD DATA 2	MD2	MD DATA 2 disc error
			disc error
		36	Mirror error	Mirr	Mirror retry over
• Description of Indication History
History code number		Description
1	The first error
N	The last error
N1	One error before the last.
N2	Two errors before the last.
R_	Total recording time

Reset the Error Display Code

After servicing, reset the error display code.

•Setting Method of Reset the Error Display Code

1. Set the test mode (see page 15).

2. Pressing the [GROUP] key or pressing the [DISPLAY] key on the remote commander activates the self-diagnosis result dis- play mode.

3. To reset the error display code, press the X key (twice) when the code is displayed (except “R_****”).

(All the data on the 1, N, N1, and N2 will be reset)

18