MZ-R900
65.Adjust with the [VOL+] key (adjusted value up) or
Remote commander LCD display
0230D751C
1C:Adjusted value
66.Press the X key.
(0D75 is blinking)
67.Press the [VOL+] key once to change the blinking portion to 0D76.
Remote commander LCD display
0230D7600
00:Adjusted value
68.Press the x key.
(00 is blinking)
69.Adjust with the [VOL+] key (adjusted value up) or
Remote commander LCD display
0230D7603
03:Adjusted value
70.Press the X key.
(0D76 is blinking)
71.Press the [VOL+] key to change the blinking portion to 0D78.
Remote commander LCD display
0230D7800
00:Adjusted value
72.Press the x key.
(00 is blinking)
73.Adjust with the [VOL+] key (adjusted value up) or
Remote commander LCD display
0230D7801
01:Adjusted value
74.Press the X key.
(0D78 is blinking)
75.Press the [VOL+] key once to change the blinking portion to 0D79.
Remote commander LCD display
0230D7900
00:Adjusted value
76.Press the x key.
(00 is blinking)
77.Adjust with the [VOL+] key (adjusted value up) or
Remote commander LCD display
0230D79E0
E0:Adjusted value
78.Press the X key. (0D79 is blinking)
79.Press the [DISPLAY] key on the remote commander for sev- eral seconds (about 3 seconds) to exit the patch data write mode (to return to the manual mode display in the test mode).
Remote commander LCD display
023 Patch 01
01:Adjusted value
80.Press the X key to write the modified data. (The adjusted value changes to CC)
81.The modified data writing is over, if the adjusted value changes to DD.
Remote commander LCD display
023***SDD
DD:Adjusted value
82. Turn the power off.
• Modified Data Writing Method (version 1.200 and later)
1.Select the manual mode of the test mode, and set item number 022 (see page 13).
Remote commander LCD display
022 PatClr CC
2.Press the X key to initialize the patch data.
(The modified data writing is over, if the adjusted value changes to DD)
Remote commander LCD display
022***SDD
DD:Adjusted value
3. Turn the power off.
26