Sharp PG-F320W Setting of Search Port, Return to Main Menu, Return to Default Settings

Page 29

Setting up the Projector Using RS-232C or Telnet

Setting of Search Port

(ADVANCED[0]Search Port)

Sets the port number used when searching for the projector from the network.

advanced>0			1
Please Enter Port Number for Search from Computer.
Valid range	: 1025 to 65535
Search Port	: 5006
Please Enter	: 5004			2

(change)	—> 5004		*

1Enter “0” and press the “Enter” key.

2Enter numerical value and press the“Enter”key. Display set numerical value (*).

Return to Main Menu

(ADVANCED[Q]Return to Main Menu)

Returns to the main SETUP MENU.

advanced>q		1
---------------------------------	SETUP MENU--------------------------------
[1]IP Address	[2]Subnet Mask	[3]Default Gateway
[4]User Name	[5]Password
[6]RS-232C Baud Rate [7]Projector Name		[8]DHCP Client
[A]Advanced Setup		[D]Disconnect All
[V]View All Setting	[S]Save & Quit	[Q]Quit Unchanged
setup>

1Enter “q” and press the “Enter” key. Returns to the SETUP MENU.

Note

•Set according to need. Normally, use with the fac- tory default setting.

Return to Default Settings

(ADVANCED[!]Restore Default

Setting)

Returns all menu setting values to the default state.

advanced>!

Restore All Setting to Default(y/n)? y

— User Setting Initialized —

1

2

1Enter “!” and press the “Enter” key.

2 Enter “y” and press the “Enter” key.

Note

•If the values for IP Address, Subnet Mask or Gate- way of the projector have been returned to the default settings via Telnet, the computer cannot be connected to the projector depending on the computer’s network settings.

-29

Image 29

Contents Setup Manual Sub 15 pin female connector Connecting Pin AssignmentsConnecting Pin Assignments Basic format RS-232C Specifications and CommandsComputer control Communication conditions ← O K CommandsControl Contents BrilliantColorTM OK or ERR PAL Network settings on the computer Setting up the Projector Network EnvironmentConnecting the Pro- jector to a Computer Setting an IP Address for the Computer Confirm or change an IP address for the setup computer Setting up a Network Connection for the Projector DNS Version 5.0 or later Controlling the Projector Using Internet ExplorerControlling the Projector via LAN Controlling the Projector Confirming the ProjectorStatus Status ControlSetting the Security Setting and AdjustingProjector Settings & Adjustments Network SecuritySetting for Sending E-mail when an Error Occurs Making General Settings for the Network NetworkMail Originator Settings GeneralOccurs Service & Support Access URL Mail Recipient SettingsWhen Connecting Using RS-232C Setting up the Projector Using RS-232C or TelnetClickStartfrom theWindows desk- top and select Run When Connecting Using TelnetAdvanced Setup Menu Setup Menu Main MenuSet Items View Setting Detail ListVView All Setting Quit without Saving Set Save Settings and QuitSSave & Quit Tings QQuit UnchangedDefault Gateway Setting IP Address SettingSubnet Mask Setting User Name SettingProjector Name Setting Password SettingDhcp Client Setting RS-232C Baud Rate SetSetting Auto Logout Time Disconnecting All ConnecEntering Advanced Setup Menu Data Port SettingAccepting All IP Addresses Setting of Accept IP Ad- dressCarrying out Network Ping Test Return to Main Menu Setting of Search PortReturn to Default Settings Resetting the Lamp Timer of the Projector via LAN Resetting the Lamp Timer of the Projector via LAN Communication cannot be established with the projector TroubleshootingTroubleshooting \ After the initialization, carry out setting again