Motorola MOTORAZRTM Charging the Battery, Turning Your Phone On, Making a Call, Answering a Call

Charging the Battery

New batteries are shipped partially charged. Before you can use your phone, install and charge the battery as described below. Some batteries perform best after several full charge/discharge cycles.

To charge the battery:

1. Insert the charger into the USB connector on your phone as shown.

2.Plug the other end of the charger into the appropriate electrical outlet.

3.When your phone indicates Charge Complete, remove the charger.

Tip: You can safely leave the charger connected to your phone after charging is complete. This will not damage the battery.

Note: When you charge the battery, the battery level indicator in the upper right corner of the display shows how much of the charging process is complete. At least 1 segment of the battery level indicator must be visible to ensure full phone functionality while charging.

Turning Your Phone On

1. Open your phone.

2. Press and hold the power key for 3 seconds.

3. If necessary, enter your 4-digit unlock code (the last 4 digits of your phone number) and press

the right soft key to unlock the phone.

Making a Call

1.Press keypad keys to dial the phone number.

2.Press N to make the call.

3.Press P to end the call and “hang up” the phone when you are finished.

-or-

4. Close the flip.

Tip: You can set the phone to answer calls when you open the flip.

To activate, press Menu > Settings > In-Call Setup > Answer Options > Open To Answer

Answering a Call

When you receive a call, your phone rings and/or vibrates and displays an incoming call message.

• Press the answer key to answer a call.

-or-

• Press N

-or-

• Open the flip to answer the phone.

PAGE 6 CHARGING THE BATTERY GETTING STARTED