note 
•If the recording memory is full,
Unavailable appears
in the display. You can not record a conversation until you clear some messages from the memory.
•Every state has different regulations governing the recording of conversations over the telephone. Make sure to check your local, state and federal laws before using this product to record any telephone conversation in order to determine that your use is in compliance with such laws or guidelines.
•You can not record intercom conversations.
•To activate this feature, you must turn the Call Screen feature on. See “Setting the Call Screen“ on
page 51.
Recording a conversation
You can record a conversation from the handset (more than two seconds and less than ten minutes).
1)During a conversation, press menu/clear.
2)Press 
/vol/∧ or 
/vol/∨ to select Call Record, and then press select/
/audio tone. Recording a Call appears on the display.
A confirmation tone that can be heard by both parties sounds during recording. To stop recording repeat above step again, Stop Recording appears.
Screening a call
From the base
To screen an incoming call, use the following steps:
After the answering system answers, the base speaker will let you hear the calls as the machine records the message. To adjust the volume, press volume/
/ 
. If you set the answering system to off, you cannot screen a call.
To mute the Call Screen, press 
.
From the handset
Press select/
/audio tone when the system is answering. To answer the call, press
talk/flash, 
or any number key, */tone/
,or #/
(when AutoTalk is set to on). The answering system will disconnect automatically.
Note:
If you press the select/
/audio tone while another handset is screening a call, you will hear a beep and you can not screen a call.
[ 5 7 ] T H E I N T E G R A T E D T E L E P H O N E A N S W E R I N G D E V I C E | w w w . u n i d e n . c o m |