Uniden DCT 748 owner manual Troubleshooting, Symptom Suggestion

Troubleshooting

If your phone is not performing to your expectations, please try these simple steps first.

	Symptom	Suggestion
	The charge LED won't illuminate	• Make sure the AC adapter is plugged into the base or the charger (if you have more than one
	when the handset is placed in	handset) and wall outlet.
		• Make sure the handset is properly seated in the cradle.
	the cradle.
		• Make sure the charging contacts on the handset are clean.
	The audio sounds weak.	• Move the handset and/or base away from metal objects or appliances and try again.
		• Make sure that you are not too far from the base.
		• Make sure that you are not too far from the base.
		• Make sure the line is not in use. If an out call is already using a line, you cannot use that line to
		make another outside call.
	Can't make or receive calls.	• Check both ends of the base telephone line cord.
		• Make sure the AC adapter is plugged into the base and wall outlet.
		• Disconnect the AC adapter for a few minutes, and then reconnect it.
		• Change the Digital Security Code (see page 15).
		• Make sure that you are not too far from the base.
	The handset doesn't ring or	• Charge the batteries in the handset for 15-20 hours by placing the handset on the base or
	receive a page.	charging cradle.
		• Change the Digital Security Code (see page 15).
		• Keep the handset away from microwave ovens, computers, remote control toys, wireless
	Severe noise interference.	microphones, alarm systems, intercoms, room monitors, fluorescent lights, and electrical
		appliances.
		• Move to another location or turn off the source of interference.
w w w . u n i d e n . c o m		T R O U B L E S H O O T I N G [ 7 0 ]

T R O U B L E S H O O T I N G