Nokia 211S manual Installation of the Mediamaster, Preparing the remote control

Page 14

Installation of the Mediamaster

The Mediamaster box should contain the following items:

the Mediamaster

a remote control with 2 AAA batteries

a SCART cable (fully connected 1.0 metre)

• a mains cable

• an owner’s manual with the software license agreement

SCART

Mains

Remote

Owner’s

cable

cable

control

manual

About the SCART sockets

The rear panel of the Mediamaster contains 2 SCART sockets

 

(see diagram). When you connect other devices to any of these

 

sockets, always use fully connected SCART cables (as supplied).

 

There are “less well specified” SCART cables on the market and

 

picture quality could be reduced if they are used.

SCART socket

 

Preparing the remote control

Remove the cover from the battery compartment at the bot- tom of the remote control.

Insert the 2 AAA (1.5 V) batteries, as shown in the diagram. Make sure that you observe the + and - markings indicated inside.

Replace the cover.

Connecting the Mediamaster to the dish

If you need to fit the F-connectors onto the cable

Prepare each end of the cable as shown in the diagram. You will need to fold back the outer braid (as shown).

Slide the F-connector onto the cable and then turn it clockwise until it grips the braid.

Ensure that 3 mm of the core is protruding from the end of the connector.

Installing the satellite dish

See the Fitting instructions provided with your satellite dish on how to install the dish.

Connect the coaxial cable, with the F-connectors fitted, from the LNB on the satellite dish to the socket marked ”ANTENNA”on the rear panel of the Mediamaster.

General

There are many different types of TV/VCR and other equipment that you can connect to the Mediamaster.

In this manual, you will see some of the most common ways to connect your equipment.

If you have problems with your connections and need help, please contact your dealer.

GB 14

15 mm

8 mm

F-connector

3 mm

Image 14
Contents User Guide Page Dear customer Page Language Switching on for the first timeQuick guide Antenna/satellite selectionChannel search One antenna/one LNB configurationTime adjustment Channel search in progressContents Nokia Mediamaster software end-user license Finland Applicable LAW & General Provisions IMPORTANT! Please read this before using the Mediamaster General information about the MediamasterRemote control Cursor buttonRear panel Front and rear panelFront panel Right-hand card slot About the smartcard and CI moduleGeneral Inserting a CI module with a smartcardConnecting the Mediamaster to the dish Installation of the MediamasterPreparing the remote control Connecting an analogue satellite receiver and a VCR Connecting to the TVConnecting a TV and VCR Connecting a HiFi system General information First time installationFirst-time installation menu Please noteMultisatellite/DiSEqC switch configura- tion Typical connection of a two-way DiSEqC switch Switch portPredefined ASTRA-/HOTBIRD-channel Motor antenna configurationType of motor Manual search Remove limitsAutomatic search Video, Audio and PCR PIDAdvanced manual search Control and the Settings folders NaviBarsControl folder User preferences Control folder Edit channelsCreate list How to enter a specific nameImportant information about editing channels Rearrange lists Delete listRename list Add/Delete channelsLock channels Access code is set to 1234 at the factoryControl folder Edit satellites To add a new satelliteDelete Satellite When your antenna is controlled by a motorEdit Satellites Control folder System info Control folder TimerTimer set-up Control folder PremiereSettings folder TV Settings folder AntennaSettings folder Channel Settings folder Access Settings folder Reinstall Settings folder TimeSettings folder SW software update Games folderViewing Mode Programme informationAudio language Temporary settingsExtended programme information Subtitle languagePremiere specific functions TV release TeletextAccess Glossary of termsTroubleshooting Problem Possible causes What to doTechnical specifications LNB / Tuner inputMenu screen structure NaviBarsPage 00000318.01