First time installation
General information
Once you have correctly connected the Mediamaster, you will also have to perform a
Please note!
The select button always confirms a selection within these menus, and pressing it will take you to the next step in the instal- lation process. However, and this is important, more than one value often has to be entered in a menu. Firstly, make all neces- sary setting changes. Then, confirm them all simultaneously by pressing select.
You can always return to the previous menu by pressing back.
Use the cursor up/cursor down button to move upwards and downwards from one line to another.
Use the cursor left/cursor right button to change settings.
You can also use the numeric buttons on the remote control to enter numeric values.
The “First-time installation” menu
This picture indicates that you have started the installation pro- cedure.
•Plug in your Mediamaster.
•The
•Press select to continue.
Language
•Select the desired menu language using the cursor up/cursor down button.
This will also become the main language for audio and subti- tling.
•Press select to continue.
Antenna/satellite selection
•Select the “One antenna/one LNB configuration” alternative if you have a single antenna equipped with one LNB for receiv- ing signals.
•Select the alternative “Multisatellite/DiSEqC switch configu- ration” alternative if you have one antenna with two or four LNBs or two antennas with one or two LNBs each for receiv- ing signals from a combination of satellites. In this cases you will need a
•Select the “Motor antenna configuration” alternative if you have an antenna motor to control your satellite antenna.
GB 17