Nokia 211S manual Typical connection of a two-way DiSEqC switch, Switch port

Page 19

First time installation

Typical connection of a two-way DiSEqC switch:

Connect the cable from the LNB that is intended for channels from the ASTRA satellite (or THOR) to the connector marked LNB 1 (A) on the switch.

Connect the cable from the HOTBIRD satellite (or SIRIUS) to

the connector marked LNB 2 (B).

Then, connect the antenna cable to the connector marked OUT on the switch.

Connect the other end of this cable to the ANTENNA input at the rear of the Mediamaster.

For each LNB that you connect to the DiSEqC switch, the following configuration has to be carried out.

As an example, the following section will describe how the LNB intended for ASTRA will be configured for DiSEqC input 1 (A) on the switch and the LNB intended for HOTBIRD will be configured for DiSEqC input 2 (B).

Switch port

Select the input for each LNB that will be connected. In this ex- ample, the DiSEqC 1 input is selected first.

LNB type

Select the correct LNB type for your configuration, e.g. “Univer- sal”.

LNB Offset voltage

If the cable from any of the LNB’s is very long, it might be nec- essary to increase the voltage to these LNB’s by 0.5 V.

In most cases nothing needs to be altered here. Leave the de- fault value as “0 V”. If the switch does not change between hori- zontal and vertical polarisation, the voltage to an LNB can be in- creased later. Increase the voltage if an LNB does not change po- larisation.

Satellite

In this example, select ASTRA because its LNB is connected to the DiSEqC 1 input on the switch.

Predefined channel

Select one of the predefined channels and adjust the antenna until a TV picture from the predefined channel is visible on the screen.

• Press opt to view the predefined channel.

Repeat this procedure for the second DiSEqC port, but this time select 2 from “Switch port” and HOTBIRD as the satellite. When the configuration of both DiSEqC ports has been com- pleted, press select. A confirmation that the DiSEqC ports have been configured will show up. You can now start searching for channels.

Press select to carry out the channel search procedure. Please refer to the “Channel search” section on page 21.

GB 19

Image 19
Contents User Guide Page Dear customer Page Antenna/satellite selection Switching on for the first timeQuick guide LanguageChannel search in progress One antenna/one LNB configurationTime adjustment Channel searchContents Nokia Mediamaster software end-user license Finland Applicable LAW & General Provisions General information about the Mediamaster IMPORTANT! Please read this before using the MediamasterCursor button Remote controlFront panel Front and rear panelRear panel Inserting a CI module with a smartcard About the smartcard and CI moduleGeneral Right-hand card slotPreparing the remote control Installation of the MediamasterConnecting the Mediamaster to the dish Connecting a TV and VCR Connecting to the TVConnecting an analogue satellite receiver and a VCR Connecting a HiFi system Please note First time installationFirst-time installation menu General informationMultisatellite/DiSEqC switch configura- tion Switch port Typical connection of a two-way DiSEqC switchType of motor Motor antenna configurationPredefined ASTRA-/HOTBIRD-channel Video, Audio and PCR PID Remove limitsAutomatic search Manual searchAdvanced manual search NaviBars Control and the Settings foldersControl folder Edit channels Control folder User preferencesImportant information about editing channels How to enter a specific nameCreate list Add/Delete channels Delete listRename list Rearrange listsTo add a new satellite Access code is set to 1234 at the factoryControl folder Edit satellites Lock channelsEdit Satellites When your antenna is controlled by a motorDelete Satellite Control folder Premiere Control folder TimerTimer set-up Control folder System infoSettings folder Channel Settings folder AntennaSettings folder TV Settings folder Access Games folder Settings folder TimeSettings folder SW software update Settings folder ReinstallProgramme information Viewing ModeSubtitle language Temporary settingsExtended programme information Audio languagePremiere specific functions Teletext TV releaseGlossary of terms AccessProblem Possible causes What to do TroubleshootingLNB / Tuner input Technical specificationsNaviBars Menu screen structurePage 00000318.01