First time installation
Advanced manual search
The information that must be entered in this menu is available in satellite TV magazines or on the Internet.
You can use this menu if you are looking for some “special” chan- nels (i.e.
Transponder frequency: Specify the frequency in MHz.
Polarisation: Select Horizontal, Vertical, Circular left or right.
Symbol rate: Enter symbol rate with the numeric buttons.
PID Video: Enter the PID (Packet Identifier) for the video signal.
PID Audio: Enter the PID for the audio signal.
PID PCR: Enter the PID for the PCR (Programme Clock Refer- ence).
Adjust motor: This alternative will only be available if you have set the motor antenna configuration. If necessary, adjust the mo- tor for the current satellite.
• Press select to tune in channels using the given parameters.
All channels that are located using the advanced manual search will automatically be given a generated name, for example, P0001 for the first channel, P0002 for the second, etc.
•Press select to save the new channel or back if you don´t want to save it.
Channel search in progress
This menu will be shown while the Mediamaster is searching for TV and radio channels.
All channels that are found will be listed on the screen.
Please note that the search procedure may take a few minutes. You can cancel the search at any time by pressing select.
When the search procedure has ended, a message will tell you how many TV and radio channels have been found.
• Press select to continue.
Time adjustment
The time is adjusted by using cursor up/cursor down, ± 1/2 an hour at a time. You can also adjust the minutes by using cursor left/cursor right.
•Press select to finish the first time installation and to open the NaBars
GB 22