Kyocera E4000 specifications Unable to turn Conflict created due to

64	Questions & Answers
Problem		Possible causes	Possible solution
Unable to turn the		Conflict created due to	First, try power cycling the phone (turn OFF then
phone on.		downloaded software	ON). If phone is still not responding, try removing
		application.	and replacing the battery. If neither of the two
			steps above correct the problem, you must "cold
			boot" the phone. Note that performing this
			procedure will remove all data, programs and
			settings including contacts that you have added to
			the phone. After completing this you will have to
			proceed with the start up procedure again. See
			"First time startup" on page 15.
			Cold boot procedure: first, remove then replace
			the battery. With the phone off, simultaneously
			hold down	,	and	until the
			reinitialization screen appears. Select Yes to
			complete the cold boot procedure.
		Use of non-approved SIM card. Take the SIM card to your service provider for
			replacement.
		Use of non-approved microSD	Check with your service provider for approved
		card.	cards.
		Battery power has been	Recharge the phone's battery.
		depleted.
		Battery contact terminals are	Seek your dealer's help to clean the terminals.
		not clean.
Shortened standby		The standby time is related to	If you are located in an area where signalling is
time.		your service provider system	weak, temporarily switch off the phone.
		configuration. The same phone
		used with different service
		providers’ systems will not
		provide exactly the same length
		of standby time.
		The battery is depleted. In high-	Use a new battery.
		temperature environments,
		battery life will be shortened.
		If you are not able to connect to	Change your location to one where the network is
		the network, the phone will	accessible, or temporarily turn off your phone.
		continue to send out signals as

it attempts to locate a base station. Doing so consumes battery power and will consequently shorten standby time.