Targus e340, I640 manual Clear PIN Number, Emulation, OAI On/Off

SpectraLink Corporation	Setup and Administration—NetLink e340/i640 Wireless Telephone
	Mitel Networks 3300 and SX-200 ICP and 5220 IP Phone emulation

Key 1-4: Scroll to the key option that corresponds to the Default Key that was entered above. Enter the encryption key as a sequence of hexadecimal characters. (Use the 2 and 3 keys to access hexadecimal digits A-F, use the Right Arrow key to advance to the next digit, and the Left Arrow key to backspace.) For 40-bit keys you will need to enter 10 digits, for 128-bit keys you will need to enter 26 digits. The display will scroll as needed.

Rotation Secret: This is used for proprietary WEP key rotation. Refer to your custom document if this feature is supported in your system.

Cisco FSR (Fast Secure Roaming) In order to provide the highest level of security without compromising voice quality on Cisco Aironet wireless LAN access points, SpectraLink and Cisco Systems have cooperated to implement the Fast Secure Roaming mechanism. FSR is designed to minimize call interruptions for NetLink Wireless Telephone users as they roam throughout a facility. Existing Aironet 350, 1100, and 1200 APs may require a firmware upgrade to support FSR. Cisco FSR requires advanced configuration of the Cisco access points in your site. See your Cisco representative for detailed documentation on configuring your access points and other required security services on your wired network. To configure Cisco FSR in your NetLink Wireless Telephone, you must enter a Radius Server username and password into each handset.

Username: Enter a username that matches an entry on your Radius server. Usernames are alphanumeric strings, and can be entered using the alphanumeric string entry technique.

Password: Enter the password that corresponds to this Username.

Clear PIN Number

The PIN number is saved in the Wireless Telephone’s local memory. If it is necessary to change the PIN number assigned to this Wireless Telephone, clear the existing number through this Admin menu option and power cycle the Wireless Telephone. The PBX will request a PIN number when the handset is powered on, just as it does with the 5220 IP Phone. Enter the PIN number and press the Save softkey. The new PIN number is saved in the Wireless Telephone’s local memory.

5220 Emulation

Disable 5220 is the default and should be used if configuring for the SX-200 ICP or the 3300 ICP is using software version 5.1 or greater. With this revision, the Mitel Networks system became capable of recognizing NetLink Wireless Telephones. If the 3300 ICP software version in use is below 5.1, select Enable 5220 to allow Mitel Networks to recognize the NetLink Wireless Telephone as a 5220 IP Phone.

OAI On/Off

SpectraLink’s Open Application Interface (OAI) enables third-party computer applications to display alphanumeric messages on the Wireless Telephone display and take input from the Wireless Telephone keypad. Refer to the Open Application Interface (OAI) Specification (Version 1.2) documentation for information about administering the OAI Gateway and the services it can provide.

PN: 72-1084-02-D.doc Page 21