| SpectraLink Corporation | Setup and |
| ||
|
|
| Mitel Networks 3300 and |
| |
|
|
|
|
|
|
| Message |
| Description | Action |
|
| No SVP IP | The Wireless Telephone is | Enter a valid NetLink SVP Server |
| |
|
| configured for “static IP” (as opposed | IP Address in the configuration |
| |
|
| to “use DHCP”) and no valid NetLink | setting or change to “use DHCP.” |
| |
|
| SVP Server address has been |
|
| |
|
| entered. |
|
| |
| No SVP Response | The NetLink SVP Server is not | This may be caused by bad radio |
| |
|
| responding to requests from the | reception or a problem with the |
| |
|
| Wireless Telephone. | NetLink SVP Server. The Wireless |
| |
|
|
|
| Telephone will keep trying to fix the |
|
|
|
|
| problem for 20 seconds, and the |
|
|
|
|
| message may clear by itself. If it |
|
|
|
|
| does not, the Wireless Telephone |
|
|
|
|
| will restart. Report this problem to |
|
|
|
|
| the system administrator if it keeps |
|
|
|
|
| happening. |
|
| No SVP Server | Wireless Telephone can’t locate SVP | IP Address configuration of |
| |
|
| Server. | NetLink SVP Server is wrong or |
| |
|
|
|
| missing. |
|
|
| SVP Server is not working. | Check error status screen on |
| |
|
|
|
| NetLink SVP Server. |
|
|
| No LAN connection at the SVP | Verify NetLink SVP Server |
| |
|
| Server | connection to LAN. |
| |
|
|
|
|
| |
| No Net Access | Cannot authenticate / associate with | Verify the AP configuration. |
| |
|
| AP |
|
|
|
| No Net Found | This indicates any of the following: |
|
| |
|
| • | No radio link | Verify that the AP is turned on. |
|
|
| • No ESSID – Autolearn not | Verify the ESSID of the wireless |
| |
|
|
| supported (or) | LAN and enter or Autolearn it |
|
|
|
| incorrect ESSID | again if required. |
|
|
|
|
|
|
|
|
| • | Out of range | Try getting closer to an AP. Check |
|
|
|
|
| to see if other Wireless |
|
|
|
|
| Telephones are working within the |
|
|
|
|
| same range of an AP. If so, check |
|
|
|
|
| the ESSID of this Wireless |
|
|
|
|
| Telephone. |
|
|
| • | Incorrect WEP settings | Verify that all the WEP settings in |
|
|
|
|
| the Wireless Telephone match |
|
|
|
|
| those in the APs. |
|
|
|
|
|
| |
| No Reg Domain | Regulatory Domain not set. | Configure the Regulatory Domain |
| |
|
|
|
| of the Wireless Telephone |
|
| Not Installed! | A required software component is | Check that all required software |
| |
|
| missing. | files are on the TFTP server, if |
| |
|
|
|
|
| |
|
|
|
| used. If the error repeats, contact |
|
|
|
|
| SpectraLink Technical Support. |
|
PN: | Page 44 |