Targus e340, I640 manual Message Description Action

SpectraLink Corporation		Setup and Administration—NetLink e340/i640 Wireless Telephone
		Mitel Networks 3300 and SX-200 ICP and 5220 IP Phone emulation
Message		Description	Action
Press End Call	Your call has ended.		Press the Power Off / End Call key
			to return to standby mode.
Restart Command	The Wireless Telephone received a		None. The Wireless Telephone
	restart command from the supported		will automatically restart in a few
	Mitel Networks VoIP solution.		seconds.
Select License	The correct protocol has not been		Using the administrative menus,
	selected from the license set.		select one license from the set to
			allow the phone to download the
			appropriate software.
Server Busy	Wireless Telephone is attempting to		None, the Wireless Telephone will
	download from a TFTP Server that is		automatically retry the download
	busy downloading other devices and		every few seconds.
	refusing additional downloads.
SKT Open Fail	Socket open fail. Occurs when the		If the PBX is inoperative and
	Wireless Telephone tries to connect		resiliency is not active or the
	to the PBX but there is no response.		Wireless Telephone cannot locate
	If resiliency is active, the Wireless		a backup PBX, turn off the
	Telephone will keep trying.		Wireless Telephone and repair the
			primary PBX. Note that it may be
			advisable to reconfigure the
			backup PBX to be the primary PBX
			if the repair is more time-consum-
			ing than the reconfiguration.
SVP Service Rej.	The NetLink SVP Server has		The Wireless Telephone will restart
	rejected a request from the Wireless		and attempt to re-register with the
	Telephone.		SVP Server, which should fix the
			problem. Report to your
			administrator if it keeps happening.
System Locked	NetLink SVP Server is locked.		Try call again later, system has
(with Busy Tone)			been locked for maintenance.
System Busy	NetLink SVP Server is busy or out of		All call paths are in use, try call
(with Busy Tone)	resources.		again in a few minutes.
TCP Rcv Timeout	If the PBX has failed, this message		Wait for the Wireless Telephone to
	may display briefly as the Wireless		cycle through attempts to connect
	Telephone tries to connect to the		to the backup PBX. See SKT Open
	backup PBX in a resilient setting.		Fail above.
	This message may be replaced by
	the SKT Open Fail message if the
	Wireless Telephone is unsuccessful
	at connecting with the backup PBX
	or if resiliency is not programmed.

PN: 72-1084-02-D.doc Page 45