Targus e340, I640 manual Wireless Telephone Status Messages, Message Description Action

SpectraLink Corporation	Setup and Administration—NetLink e340/i640 Wireless Telephone
	Mitel Networks 3300 and SX-200 ICP and 5220 IP Phone emulation

11.3 Wireless Telephone Status Messages

Wireless Telephone status messages provide information about the NetLink e340/i640 Wireless Telephone's communication with the AP and host telephone system. The following table summarizes the status messages, in alphabetical order.

Message	Description	Action
3 chirps	Wireless Telephone is not able to	None. This is only a warning, the
	communicate with the best AP,	call will handoff to the best AP
	probably because that AP has no	once it becomes available.
	bandwidth available.
Bad Config	Some needed configuration	Check all required Wireless
	parameter has not been set.	Telephone configuration
		parameters for valid settings.
Bad ESSID	The Wireless Telephone is	Enter an ESSID in the
	configured for “static ESSID” (as	configuration settings or change to
	opposed to “Learn once” or “Learn	one of the “Learn” modes.
	always” and no ESSID has been
	entered.
(battery icon), Low	Low battery	In call: the battery icon displays
Battery and beep		and a soft beep will be heard when
		the user is on the Wireless
		Telephone and the battery charge
		is low. User has 15–30 minutes of
		battery life left.
		Not in call: The battery icon
		displays whenever the battery
		charge is low The message Low
		Battery and a beep indicate a
		critically low battery charge when
		user is not on the Wireless
		Telephone. The Wireless
		Telephone will not work until the
		Battery Pack is charged.
Can’t Renew DHCP	The functional code is not able to get	Configuration problem. Check the
	a lease renewal.	gateway address in the DHCP
		server.
Charging …	The Wireless Telephone is charging	No action needed.
	in the Desktop Charger.
Charge Complete	The Wireless Telephone is now fully	No action needed.
	charged.
Checking Code	Wireless Telephone is contacting the	None, this message should only
	TFTP Server to determine if it has a	last for approximately one second.
	newer version of software that	If message remains displayed,
	should be downloaded.	power off and contact SpectraLink
		customer support.
Checking DHCP IP	The Wireless Telephone is retrieving	None. This is informational only.
	DHCP information from the DHCP
	server.

PN: 72-1084-02-D.doc Page 41