Targus e340, I640 manual Solving Coverage Issues, Confirm Supported Data Rates

SpectraLink Corporation	Setup and Administration—NetLink e340/i640 Wireless Telephone
	Mitel Networks 3300 and SX-200 ICP and 5220 IP Phone emulation

Confirm Supported Data Rates

Press FCN to toggle to the Detail function. Use this information to confirm signal strength and supported data rates.

#: Full MAC dB Ch 1b2b5b11b

Detl

•# is the number (1-4) of the AP

•Full MAC is the MAC address of the AP

•dB is the signal strength of the AP

•Ch is the channel of the AP

•1b2b5b11b is an example of the data rate that may be displayed

Walk around the site to determine supported data rates, one AP at a time. In any location you may use the Right Arrow key to display the second best AP, arrow again to the third best, and so on to the fourth best. The Left Arrow key steps you back to the first best.

Each data rate (1,2,5.5, or 11Mb/s) that is supported by the AP is shown. Those rates that are in the Basic Rate set (sometimes referred to as “required” rates) are indicated by a ‘b’ following the rate number. The Supported and Basic data rate(s) should be the same on all APs as is appropriate for your environment.

9.3Solving Coverage Issues

Coverage issues are best resolved by adding and/or relocating access points.

Overlap issues may be resolved by reassigning channels to the access points or by relocating the access points.

PN: 72-1084-02-D.doc Page 37