Weslo WETL20708.0 user manual HOW to Fold and Move the Treadmill, HOW to Move the Treadmill

Page 15

HOW TO FOLD AND MOVE THE TREADMILL

HOW TO FOLD THE TREADMILL FOR STORAGE Remove the key and unplug the power cord. CAUTION: You must be able to safely lift 45 lbs. (20 kg) to raise, lower, or move the treadmill.

1. Hold the metal frame firmly in the location shown by the arrow at the right. CAUTION: To decrease the pos- sibility of injury, do not lift the frame by the plastic foot rails. Make sure to bend your legs and keep your back straight as you raise the frame. Raise the frame about halfway to the vertical position.

2. Raise the frame slightly and pull the latch knob to the right. Pivot the frame upward and release the latch knob. Raise the frame until the latch knob locks into the storage position. Make sure that the latch knob is locked in the storage position.

To protect the floor or carpet from damage, place a mat under the treadmill. Keep the treadmill out of di- rect sunlight. Do not leave the treadmill in the stor- age position in temperatures above 85° F (30° C).

HOW TO MOVE THE TREADMILL

Before moving the treadmill, convert the treadmill to the storage position as described above. Make sure that the latch knob is locked in the storage position.

1. Hold one handrail and place one foot against one of the wheels.

2. Tilt the treadmill back until it rolls freely on the wheels. Carefully move the treadmill to the desired location. To reduce the risk of injury, use extreme caution while moving the treadmill. Do not move the treadmill over an uneven surface.

3. Place one foot against one of the wheels, and carefully lower the treadmill until it is resting in the storage posi- tion.

Frame

Frame

Latch

Knob

Handrail

Wheel

15

Image 15
Contents Model No. WETL20708.0 Serial No QUESTIONS?DecalTable of Contents Pulse sensor is intended only as an exer Important PrecautionsVarious factors, including your movement May affect the accuracy of heart rate readingsInstructions Before YOU Begin Assembly Handrails 34, 86. Make sure not to pinch Wire Harness See the inset drawing. Tie the wire tieOn the Base 79. Make sure not to pinch Wire Harness See the inset drawing in . Tie the wire tieConnector Console Back Connectors Crossbar 83. Make sure that no wires are Pinched See the lower drawing. Press the end Two small inset drawings. Using your finCareful not to crack the Motor Hood not Shown Avoid losing the Gas Spring Clip. Note ExtraOperation and Adjustment HOW to Plug in the Power CordPRE-LUBRICATED Walking Belt Console Diagram HOW to USE the Console Insert the key into the console. See Start the walking beltMonitor your progress with the display. As you exer Measure your heart rate if desired HOW to Level the TreadmillHOW to Move the Treadmill HOW to Fold and Move the TreadmillHOW to Lower the Treadmill for USE Displays of the console do not function properly TroubleshootingProblem Solution Power turns off during useTop View Problem The walking belt slows when walked on Key and Unplug the Power CORD. UsingWalking belt. If the walking belt has shifted to Exercise Frequency Exercise GuidelinesExercise Intensity Workout GuidelinesKey No. Qty Description Part LIST-Model No. WETL20708.081627 Exploded Drawing B-Model No. WETL20708.0 R0908A Exploded Drawing C-Model No. WETL20708.0 R0908A Recycling Information Ordering Replacement Parts