Locate the Reed Switch (88) and the Magnet (41) on the left side of the Pulley (43). Turn the Pulley until the Magnet is aligned with the Reed Switch. Make sure that the gap between the Magnet and the Reed Switch is about 1/8 in. (3 mm). If necessary, loosen the M4.2 x 12mm Screw (30), move the Reed Switch slightly, and then retighten the Screw. Reattach the Motor Hood (not shown) and run the treadmill for a few minutes to check for a correct speed reading.
1/8 in. | 43 |
30 | |
88 | 41 |
Top View |
|
PROBLEM: The walking belt slows when walked on |
|
|
SOLUTION: a. If an extension cord is needed, use only a | ||
than 5 ft. (1.5 m). |
|
|
b. If the walking belt is overtightened, treadmill perfor- | b |
|
mance may decrease and the walking belt may be- |
| |
come damaged. Remove the key and UNPLUG THE |
| |
POWER CORD. Using the hex key, turn both idler |
| |
roller bolts counterclockwise, 1/4 of a turn. When the |
|
|
walking belt is properly tightened, you should be able |
|
|
to lift each edge of the walking belt 2 to 3 in. (5 to 7 |
|
|
cm) off the walking platform. Be careful to keep the |
|
|
walking belt centered. Then, plug in the power cord, |
| 12 |
insert the key, and run the treadmill for a few minutes. |
| |
Repeat until the walking belt is properly tightened. |
|
|
c. If the walking belt still slows when walked on, see the front cover of this manual. | ||
PROBLEM: The walking belt is |
|
|
SOLUTION: a. If the walking belt has shifted to the left, first re- | a |
|
move the key and UNPLUG THE POWER CORD. |
| |
Using the hex key, turn the left idler roller bolt clock- |
|
|
wise 1/2 of a turn. Be careful not to overtighten the |
|
|
walking belt. If the walking belt has shifted to the |
|
|
right, turn the left idler roller bolt counterclockwise 1/2 |
|
|
of a turn. Then, plug in the power cord, insert the key, |
|
|
and run the treadmill for a few minutes. Repeat until |
|
|
the walking belt is centered. |
|
|
b. If the walking belt slips when walked on, first remove | b |
|
the key and UNPLUG THE POWER CORD. Using the |
| |
hex key, turn both idler roller bolts clockwise, 1/4 of a |
|
|
turn. When the walking belt is correctly tightened, you |
|
|
should be able to lift each edge of the walking belt 2 to |
|
|
3 in. (5 to 7 cm) off the walking platform. Be careful to |
|
|
keep the walking belt centered. Then, plug in the |
|
|
power cord, insert the key, and carefully walk on the |
|
|
treadmill for a few minutes. Repeat until the walking |
|
|
belt is properly tightened. |
|
|
18