TROUBLESHOOTING
Most treadmill problems can be solved by following the steps below. Find the symptom that applies, and follow the steps listed. If further assistance is needed, please see the front cover of this manual. PROBLEM: The power does not turn on
SOLUTION: a. Make sure that the power cord is plugged into a properly earthed outlet (see page 11). If an exten- sion cord is needed, use only a
b. After the power cord has been plugged in, make sure that the key is inserted into the console. c. Check the reset/off circuit breaker located on the
treadmill frame near the power cord. If the switch protrudes as shown, the circuit breaker has tripped. To reset the circuit breaker, wait for five
minutes and then press the switch back in.
PROBLEM:
SOLUTION:
PROBLEM:
SOLUTION:
The power turns off during use |
|
|
|
a. Check the reset/off circuit breaker (see the drawing above). If the circuit breaker has tripped, wait | |||
for five minutes and then press the switch back in. |
|
|
|
b. Make sure that the power cord is plugged in. If the power cord is plugged in, unplug it, wait for | |||
five minutes, and then plug it back in. |
|
|
|
c. Remove the key from the console. Reinsert the key fully into the console. |
| ||
d. If the treadmill still will not run, please see the front cover of this manual. |
| ||
The displays of the console do not function properly |
|
|
|
a. Remove the key from the console and UNPLUG THE | a |
|
|
POWER CORD. Next, remove the five M4.2 x 12mm | 30 | 53 30 | |
Hood Screws (30) and pivot off the Motor Hood (53). |
| ||
30
17