Newcon Optik LRB 6000CI operation manual Operation Instructions, Installing the battery

Page 14

5. OPERATION INSTRUCTIONS

Installing the battery

Open the battery compartment using a suitable tool, or a coin.

Insert a 9V Lithium non-magnetic battery provided with your device

Connect the battery to the battery snap

Refit the battery compartment and tighten the screw.

If the battery compartment cover does not close tightly and evenly, check that the battery snap wires are neatly packed inside the battery compartment and the cover is aligned over the edge of the battery compartment.

Note: Battery in metal casing will diminish compass accuracy. Non-magnetic batteries should be used for the utmost compass performance.

LRB 6000CI is equipped with battery monitoring sensor. If display shows “LOW BATTERY” warning when battery voltage falls below 6.5V this indicates that the battery is used up. You can still get readings, but the battery needs to be replaced soon.

10

Page 13 Page 15
Image 14
Page 13 Page 15
Contents LRB 6000CI Page Important Information Read prior to activationPage Table of Contents Brief Description Key Features of the LRB 6000CI Laser Rangefinder Binoculars Device Appearance Front viewRear view Display Delivery SET Range Finder SpecificationsOptics Or Inclinometer PowerCompass EnvironmentalInstalling the battery Operation InstructionsUsing the Device Factors affecting measuring distance Target selection logic Individual Measurement and Scanning regimesOperation and service modes Page Accuracy correction Std Sd, d DCESetting interface format Compass calibrationGating mode Data Recall mode Computer interconnectivity Short mode switching scheme GPS interconnectivityBest Measuring Technique Page Storage and Maintenance Troubleshooting Black dots are visible on LCDWarranty What This Warranty Does Not CoverAll other countries Customer SupportUS customers Quality Certificate Page Page Newcon Optik
Top Page Image Contents