Using the Device
The LRB 6000CI operational procedures are design to allow the user to use most applicable options in the fastest time possible. To activate it, press and hold Action button (6, Fig.1) for one second. At start the unit comes into Ready to Measure mode indicated by the word ‘READY’ on the display visible through the eyepiece.
Pressing Action button (6, Fig. 1) again will initiate measurement procedure. The results of measurement are displayed in default form of “Distance (M), Azimuth (mils) and Elevation (mils)” measurement parameters also can be modified to user preference (see Setup Mode).
If results of measurement are unreliable four dashes
‘) will be displayed in the area (4, Fig. 3). |
Pressing Mode button (5, Fig. 1) gives the user the options to change settings from Factory default to specific modes required by user. For full list of Mode options please refer to Operation and Service modes
If the target is located below the unit the result of vertical measurement (elevation or height) will be preceded with minus
11