Newcon Optik LRB 3000PRO operation manual Operation and service modes

Page 17

parameters are measured in the Scanning regime though both will be quickly displayed, the second one may be difficult to register by eye. Nevertheless all data is recorded and may be recalled (see Data Recall mode for details.)

Operation and service modes

Pressing Mode button (3, Fig.1) in Ready mode switches the unit between modes of operation, to activate any desired mode from the menu you must confirm your selection by pressing Action button (4, Fig.1)

The unit has the following modes of operation:

ƒReady – Unit is ready to perform measurements

ƒdFLt – sets default mode of operation with factory settings,

ƒStd – allows the user to select single action measurements:

oDistance only

oCompass Only

oSpeed Only

oSpeed + Distance

oDistance +Compass

ƒUnit – allows user to select units of measurements,

oDistance from M to Y

13

Page 16 Page 18
Image 17
Page 16 Page 18
Contents LRB 3000PRO Page Read prior to activation Important InformationPage Table of Contents Principle of operation Brief DescriptionKey Features Device Appearance Page Display Optional accessories SpecificationsDelivery SET Standard delivery setRange Finder PowerSpeed measurement CompassEnvironmental Operation InstructionsMechanics Preparing device for operationMeasurement procedure Target selection logic Factors affecting measuring distanceIndividual Measurement and Scanning regimes Operation and service modes Page Sd, d Accuracy correctionCompass calibration Data Recall mode Best Measuring Technique Storage and Maintenance Compass readings are equal to zero at any direction TroubleshootingWhat This Warranty Does Not Cover WarrantyCustomer Support Serial number Quality CertificateNewcon Optik
Top Page Image Contents