Newcon Optik LRB 3000PRO operation manual Data Recall mode

Page 21

Data Recall mode

In Data Recall mode results of the last 10 measurements can be displayed.

Measurement results are saved in on-board memory in sets depending on the parameters set for measuring, for instance, if only distance is measured - the set will consist of one number, if distance and azimuth are measured – the set will consist of two numbers.

To enter Data Recall mode select rEc from main menu. First measurement set number (display name: rEc 1) will start flashing.

Pressing M button moves the unit along the list of measurement set numbers and measurement results: rEc 1, distance 1, azimuth 1,

rEc 2, distance 2, azimuth 2, rEc 0, distance 0, azimuth 0.

Measurement sets are numbered in reverse order: first recalled set is the result of the last measurement. If any parameter has not been actually measured it will not be recalled.

Pressing A button at any moment within the list of recalled results brings the unit to Ready to Measure mode.

Choosing cLr at the end of recalled data will erase the device memory.

17

Page 20 Page 22
Image 21
Page 20 Page 22
Contents LRB 3000PRO Page Read prior to activation Important InformationPage Table of Contents Principle of operation Brief DescriptionKey Features Device Appearance Page Display Optional accessories SpecificationsDelivery SET Standard delivery setRange Finder PowerSpeed measurement CompassEnvironmental Operation InstructionsMechanics Preparing device for operationMeasurement procedure Target selection logic Factors affecting measuring distanceIndividual Measurement and Scanning regimes Operation and service modes Page Sd, d Accuracy correctionCompass calibration Data Recall mode Best Measuring Technique Storage and Maintenance Compass readings are equal to zero at any direction TroubleshootingWhat This Warranty Does Not Cover WarrantyCustomer Support Serial number Quality CertificateNewcon Optik
Top Page Image Contents