Assembly

For your convenience, the ARC SKIER PLUS is shipped assembled in the stowaway position. Follow the instruc- tions below to set up the ARC SKIER PLUS. No tools are required.

1.Raise the Upright (26) to the position shown. Slide the M10 Washer (18) onto the Lock Knob (30). Insert the Lock Knob into the indicated bracket and tighten the Lock Knob Into the lower end of the UpdghL

2.The Console (27) requires two "AA"batteries (not included). Alkaline batteries are recommended.

To install batteries, first slide up the Battery Cover

(46). Carefully remove the battery clip from the Console (27). Insert two batteries into the battery

clip. Make sure that the negative (-) ends of theBattery Clip batteries are touching the springs. Insert the bat-

tery clip into the Console and close the Battery

Cover.

3.Before using the cross-country skier, the included all- icon oil should be applied. Apply a few drops of sili- con all to the Ski Rails (1) where the Ski Pedal Wheels (23) make contact.

1---Apply Silicon Oil

Make sure that all pads are securely tightened. The use of the remaining parts will be explained in the following section.